Graco Pack n Play Series User manual

OWNER'S MANUAL
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.

Failure to follow these warnings and the
instructions could result in serious injury or death.
Setting Up the Playard
•THIS PRODUCT REQUIRES ADULT ASSEMBLY.
• Keep fingers clear of top corners during setup. Be sure playard
is completely set up before use. Check that the four top rails are
completely latched, the center of the floor is pushed down, the
mattress/pad is flat, the straps are securely fastened to the bottom of
the unit and the four corners are tucked under the stiffeners. Always
follow the instructions in the owner’s manual to set up the playard.
Using the Playard
• The playard is for playing or sleeping. When used for playing, never
leave child unattended and always keep child in view. When used for
sleeping, you must still provide the supervision necessary for the
continued safety of your child.
• Always keep the playard away from hazards in the area that may
injure your child.
• When child is able to pull to standing position, remove large toys
and other objects that could serve as steps for climbing out.
• Stop using this product when your child reaches 35 inches (89 cm) in
height, weighs more than 30 pounds (14 kg), or is able to climb out.
• Do not modify playard or add any attachments that are not
listed in the owner’s manual, including an add-on bassinet.
• Child can become entrapped and die when improvised netting or
covers are placed on top of a playard. Never add such items to
confine child in playard.
• NEVER leave child in product with side lowered. Be sure side is in
raised and locked position whenever child is in product.
• If refinishing, use a nontoxic finish specified for children’s products.

Avoiding Suffocation Hazards
• Unlike cribs that have rigid sides, the playard has flexible sides.
As a result, the playard mattress/pad is specially designed to prevent
suffocation. The playard mattress/pad has a solid base, a certain
length and width, and is less than one inch thick in order to meet
safety standards. Using a thicker or a different sized mattress/pad may
allow a child’s head to get between mattress/pad and the side of the
playard causing suffocation.
•Infants can suffocate
• In gaps between a mattress too small or too thick and
products sides
• On soft bedding.
NEVER add a mattress, pillow, comforter or padding. Use ONLY
mattress pad provided by Graco.
• To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their backs to sleep, unless otherwise advised
by your physician.
• Never use plastic shipping bags or other plastic film as mattress covers
not sold and intended for that purpose. They can cause suffocation.
• NEVER use a water mattress with the playard.
Avoiding Strangulation Hazards
• Strings and cords can cause strangulation. Keep strings and cords
away from child.
• NEVER place the playard near a window where cords from
blinds or drapes can strangle a child.
• NEVER hang strings on or over the playard.
• NEVER place items with a string around a child’s neck, such as hood
strings, pacifier cords, etc.
• NEVER attach strings to toys.
This product is not intended for commercial use.

Parts list
ALL MODELS
This model may not include some features shown below. Check
that you have all the parts for this model BEFORE assembling your
product. If any parts are missing, call Customer Service.
Tools required:
Phillips
Screwdriver
2X
2X
2X
2X
FEATURES ON CERTAIN MODELS

Setup
DO NOT push center
down yet.
SNAP!
1
2
3

• When setting up, lock rails BEFORE lowering center.
Be sure top rails have become rigid. If not, pull up again until they
are rigid. If top rails do not latch, lift the center of the floor higher.
Hold one end of the unit up and
push the center of the floor down.
4
5
SNAP!

Always use mattress/pad
soft side up.
6

7
8
Put two tabs under mattress/pad
through button holes and fasten
securely on bottom of unit.
Tuck four corners of mattress/
pad under corner stiffeners.
7a Pull strap through
bottom of playard
and wrap around
tube and refasten
snap. Repeat on
other corners.
SNAP!

To Fold
Release straps.
DO NOT unlock top rails yet.
Center of floor must be
halfway up before top rails
will unlock.
9
10

Center of floor must be up.
1. Lift up slightly on the top rail.
2. Push in on the button located
on the side of the top rail to
release the two tubes.
3. Push down.
• If top rails do not unlatch, DO
NOT FORCE. Lift the center of
the floor higher.
•Both tubes must be released
for the top rail to fold.
11

Do not force. If unit will not fold, look
for a partially latched top rail. Squeeze
the latch button to release the rail.
12
13
14

To Cover
Cover unit with handle out.
Zip together.
15
16

Accessories (On certain models)
Bassinet
WARNING
SUFFOCATION HAZARD Infants have suffocated:
• In gaps between extra padding and side of the bassinet, and
• On soft bedding.
Use ONLY mattress/pad provided by Graco. NEVER add a pillow,
comforter or another mattress for padding.
• FALL HAZARD: To help prevent falls, do not use this product when
the infant begins to push up on hands and knees or weighs over
15 lbs (6.8 kg), whichever comes first.
• Use bassinet with only one child at a time.
• Never place a child under the bassinet.
• The bassinet must be fully assembled and installed, including four
metal tubes, eight clips and mattress/pad, before using. Do not
modify bassinet or add any attachments that are not listed in the
owner’s manual.
• DO NOT store the bassinet in the playard while in use.
• To help prevent heat build-up inside the playard and to avoid
overheating your child, when using the bassinet DO NOT use an
outdoor canopy.
• To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their backs to sleep, unless otherwise advised
by your physician.
• If a sheet is used with the pad use only the one provided by Graco
or one specifically designed to fit the dimensions of the bassinet.
• Never place child in bassinet while seat is attached.
This model may not include some
features shown.

You will need to remove the
mattress/pad from the bottom
of the playard to use inside your
bassinet.
18
NOTE: Bassinet mounts should
always be attached on the end
with the wheels as shown.
Insert tapered end of bar into end of
other bar with hole in it. Repeat with
other set of bars.
CHECK: Tubes MUST be assembled
before placing mattress/pad in bassinet.
17
Mounts
8 Clips

Open the battery compartment lid by
inserting a screwdriver in the slot. Insert one
D (LR20) cell battery (not included).
Replace lid.
Cord in bottom of bassinet.
21
20
19

Vibration must be fastened tight
and centered on the webbing
strap to work properly.
Remove 2 screws from back of
electronics module.
Remove battery door and insert
3-AA (LR06) batteries (not
included). Replace door and
screws.
24
23
22

27
26
25
SNAP!

Keep the batteries out of children’s reach.
Any battery may leak battery acid if mixed with a different battery
type, if inserted incorrectly (put in backwards) or if all batteries are
not replaced or recharged at the same time. Do not mix old and new
batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
Any battery may leak battery acid or explode if disposed of in
fire or an attempt is made to charge a battery not intended to be
recharged. Never recharge a cell of one type in a recharger made for
a cell of another type.
Discard leaky batteries immediately. Leaky batteries can cause
skin burns or other personal injury. When discarding batteries, be sure
to dispose of them in the proper manner, according to your state and
local regulations.
Always remove batteries if the product is not going to be used
for a month or more. Batteries left in the unit may leak and cause
damage.
Recommended type batteries—alkaline disposables. NEVER mix
battery types. Change batteries when product ceases to operate
satisfactorily.
TROUBLESHOOTING: If your device is not functioning
properly, check for the following problems:
1. No batteries in electronics module.
2. Batteries dead.
3. Batteries in backwards—check “+” and “-”.
4. Corrosion on battery terminals. Rotate batteries in place
against terminals, or clean with sandpaper or steel wool if
corrosion is severe.
5. Batteries too weak.
For Safe Battery Use

The vibration unit may ONLY
be used with the bassinet or
seat.
WARNING
You must remove the module
from the unit when your child
can pull up to a standing
position.
TO TURN OFF ANY FUNCTION— Press and hold the button for
2 seconds.
Using Electronics Module
VIBRATION— Press once for high, twice for low,
three times to turn off. Automatically shuts off in
25 minutes.
28