Graham Field Lumex 7921RA Parts list manual

1
7921RA: BATH SEAT WITH ARMS AND BACKREST /
7931RA: BATH SEAT WITH ARMS
ASSEMBLY AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
PARA INSTRUCCIONES EN ESPAÑOL, VÉASE LA PÁGINA 5
IMPORTANT SAFETY INFORMATION: PLEASE READ
WARNING: Important! Read and understand these instructions before assembling or
using the Bath Seat. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If the
Bath Seat is not properly assembled and adjusted, personal injury and damage to the Bath
Seat could result.
WARNING: If components are damaged or missing, contact your distributor immediately.
DO NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement
parts could cause personal injury and damage to the Bath Seat.
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
INTENDED USE
The 7921RA / 7931RA Bath Seat is intended for use by individuals who require seating support
while bathing or showering. It is designed to be placed fully inside the bathtub or shower.
Contraindications
WARNING: This product has a weight limit of 350 lb, EVENLY DISTRIBUTED.
WARNING: DO NOT use this product as a transfer bench or climbing device.
 WARNING:Usethisproductonlywithtuboorswiderthan18 3/4".
ASSEMBLY
7921RA / 7931RA Bath Seat with Arms
(7921RA with Backrest Shown Above)
suction feet
leg extensions
leg height
adjustment
lock button
legs
arms
arm lock button
backrest
lock button backrest tubes
(7921RA only)
backrest
(7921RA only)
seat
backrest
channel guides
leg receptacles
arm sockets
1. Remove all components (shown above) from the box.

2
2. Place the seat facedown on a at surface.
3. Locate the four legs.
4. Install legs on frame: press lock button on each
plastic leg sleeve end and slide the leg onto the
frame until the button clicks into place.
5. Adjust leg extension height by pushing in the leg
height adjustment lock button, moving to the
desired hole height, and releasing button until it
clicks into place.
Info: If assembling 7921RA (with backrest),
proceed to step 6.
If assembling 7931RA (without backrest),
proceed to step 9.
6. Locate backrest tubes and backrest.
7. Install backrest tubes on backrest: press each
backrest tube lock button and slide tube onto
backrest until button clicks into place.
8. Install backrest on bath seat: press both backrest
lock buttons and slide backrest tubes into bath
seat backrest channel guides until buttons click
into place.
9. Attach arms: press both arm lock buttons and
insert each arm into arm socket until arm clicks
into place.
WARNING: Ensure all lock buttons have clicked into place and all lock buttons protrude
fully through holes. Contact your GF authorized distributor immediately if you see any
issuewitht,form,function,orsafety.
WARNING: Ensure the Bath Seat is assembled as described. If the Bath Seat is not properly
assembled and installed, personal injury and damage to the Bath Seat could result.
7921RA Bath Seat
with Arms and Backrest
step 9
step 7
step 8
step 4
step 5

3
OPERATION
Adjusting Leg Height
Push in the leg height adjustment lock button and move
leg extension to the desired height position — you
will hear it click into place. Ensure that all four legs
are locked into place at the same height and all leg
height adjustment lock buttons protrude fully through
adjustment holes.
WARNING: Ensure all Bath Seat components are
secure before each use.
Center of Balance During Use
The point where the Bath Seat will tip forward,
rearward or sideward is determined by its center of
balance and stability, and the center of balance and
stability is affected by the user’s body position and
weight distribution. If you fail to heed the following
warnings, falling or tipping may occur and could cause
severe personal injury.
WARNING: To avoid falling or tipping:
Have someone help you until you know the
balance points of your Bath Seat and how to avoid
tipping.
Do not put downward weight on one armrest at a
time. If using the armrest for balance, hold both
armrests at once to distribute your weight equally.
Do not put downward weight on the backrest.
Do not reach or lean if you must shift your weight
to do so. Ask for help or use a device to extend
your reach.
Never try to reach an object if you must move
forward in your seat and your buttocks do not
stay in full contact with the seat.
Never lean backward to reach an object.
MAINTENANCE
WARNING: Check the Bath Seat weekly for signs of damage or cracking. If damage or
cracking of any component of the Bath Seat is found, DO NOT use the Bath Seat. Contact
your Graham-Field authorized provider.
To clean the Bath Seat, wash it with soap and water or a mild detergent, then rinse. Ensure the
Bath Seat is rinsed well before use.
7921RA Bath Seat
with Arms and Backrest
Shown Assembled
7931RA Bath Seat with Arms
Shown Assembled

4
LIMITED WARRANTY
SCOPE OF WARRANTY
GF Health Products, Inc. (“GF”) warrants to the original purchaser only that it will replace or repair components, at GF’s sole
discretion, that are defective in material or workmanship under normal use and service. All warranties are conditioned upon the
proper use of the products strictly in accordance with good commercial practice and applicable GF instructions and manuals,
including proper use and maintenance. To the extent that a component is warranted by a third party, GF conveys all of its rights
under that warranty to the original purchaser, to the extent permitted. This limited warranty shall only apply to defects that are
reported to GF’s customer service team within the applicable warranty period and which, upon examination by GF or its authorized
representative, prove to be a warranty item. This limited warranty is not transferable.
The warranted components and time period are set forth below:
Frame .................................................................................................................three (3) years
Seat/back, leg extensions, and arms.....................................................................six (6) months
Normal wear components such as tips, wheels/casters, and handgrips.................three (3) months
The applicable warranty period shall commence from date of shipment to the original customer, unless there is an expiration date
on the component in which case the warranty shall expire on the earlier of warranty period or the expiration date.
OBTAINING WARRANTY SERVICE
This limited warranty shall only apply to defects that are reported to the Distributor from whom the Customer purchased the
product within the applicable warranty period. If there is not a Distributor, you must contact GF directly by calling 1.770.368.4700,
sending a fax request to 1.770.368.2386, or by e-mailing a request to cs@grahameld.com. Specic directions will be provided by the
Customer Service Representative. Failure to abide by the specic directions will result in denial of the warranty claim.
EXCLUSIONS
The warranty does not cover and GF shall not be liable for the following:
1) Defects, damage, or other conditions caused, in whole or in part, by misuse, abuse, negligence, alteration, accident, freight damage, tampering or failure
to seek and obtain repair or replacement in a timely manner;
2) Products which are not installed, used, or properly cleaned and maintained as required in the ocial manual for the applicable product;
3) Products considered to be of a non-durable nature including, but not limited to: lters, fuses, gaskets, lubricants, and charts;
4) Accessories or parts not provided by GF;
5) Charges by anyone for adjustments, repairs, replacement parts, installation or other work performed upon or in connection with such products which
are not expressly authorized in writing, in advance, by GF;
6) Any labor or shipping charges incurred in the replacement part installation or repair;
7) Costs and expenses of regular maintenance and cleaning; and
8) Representations and warranties made by any person or entity other than GF.
ENTIRE WARRANTY, EXCLUSIVE REMEDY AND CONSEQUENTIAL DAMAGES DISCLAIMER
THIS WARRANTY IS GF’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. GF MAKES
NO IMPLIED WARRANTIES OF ANY KIND INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. IF ANY MODEL OR SAMPLE WAS SHOWN TO THE CUSTOMER, SUCH MODEL OR SAMPLE WAS USED
MERELY TO ILLUSTRATE THE GENERAL TYPE AND QUALITY OF THE PRODUCT AND NOT TO REPRESENT THAT THE PRODUCT
WOULD NECESSARILY CONFORM TO THE MODEL OR SAMPLE IN ALL RESPECTS. THIS WARRANTY IS LIMITED TO THE REPAIR
OR REPLACEMENT OF THE DEFECTIVE PARTS. GF SHALL NOT BE LIABLE FOR AND HEREBY DISCLAIMS ANY DIRECT, SPECIAL,
INDIRECT, INCIDENTAL, EXEMPLARY OR CONSEQUENTIAL DAMAGES, INCLUDING, BUT NOT LIMITED TO: DAMAGES FOR LOSS OF
PROFITS OR INCOME, LOSS OF USE, DOWNTIME, COVER, OR EMPLOYEE OR INDEPENDENT CONTRACTOR WAGES, PAYMENTS AND
BENEFITS.
The warranties contained herein contain all the representations and warranties with respect to the subject matter of this
document, and supersede all prior negotiations, agreements and understandings with respect thereto. The recipient of this
document hereby acknowledges and represents that it has not relied on any representation, assertion, guarantee, warranty,
collateral contract or other assurance, except those set out in this document.
For additional information on this product or this warranty, please contact a GF Customer Service Representative.
NOTES:
1) Additional terms and conditions may apply.
2) Freight claims must be notated on the appropriate shipping documents and must be made with immediacy. International, federal and state regulations
govern specic requirements for freight claims. Failure to abide by those regulations may result in a denial of the freight claim. GF will assist you in
ling the freight claim.
3) Claims for any short shipment must be made within three (3) days of the invoice date.