3
1.1 Use the W11 10mm wrench and the ALLEN WRENCH to tighten the ML01/S02 nut and bolt combination. Follow
the diagrams to put your potting bench together.
1.2 Attach THG-04 to the outside of THG-01 and the THG-02 using the provided bolts and nuts as shown in diagram
for the top and bottom level. Repeat on all corners of the table.
1.3 Attach the (18) THG-03’s to the (4) THG-01’s with the ML01/S02 nut and bolt combos as shown in the diagram.
Note that the THG-03 slats will rest on top of the THG-01 supports on both levels of the shelf.
1.4 Attach the (16) THG-05 brackets as shown with the ML01/S02 nut and bolt combos on the outside of the THG-01,
THG-02 and THG-04. Repeat on both levels and all corners as shown in the diagram.
1.5 Confirm that all nut and bolt combos are tightened, then attach the (4) FOOT CAPS to the bottom edges of the
(4) THG-04’s.
INSTRUCTIONS
THG-05
THG-05
THG-02 THG-01
THG-04
THG-01
FOOT CAP
THG-03
