GRASS VALLEY 8950ADC User manual

J1 J2
J3 J4
J5 J6
J7 J8
J9 J10
SDI
Output
SDI
Output
Not
Used
Color Black
or Composite
Sync
V/R
U/B
Loopthru
Y/G
Ref
Loop
8900V-R
Remote
Timing
Generator
Analog
Filter
Micro-
processor
YUV
Converter
Mux
& 601
Encoder
LEDs
SDI
Delay
ADC Gain
Y/G
U/B
V/R
Ext Ref
Controls
Specifications Ordering Information
70
The 8950ADC converts a component analog
video signal from analog VTRs and switchers
to serial digital, which can then be routed
through a digital router or switcher, or stored
on a digital video disk recorder. It offers 2.5
horizontal lines of user-controllable delay to
adjust the output timing, and inserts EDH
code to help track errors downstream.
All possible adjustments to this card can be
performed directly on the module. When the
8900NET card is installed in the frame, you
gain immediate access to remote control and
monitoring.
Key Features
10-bit A-to-D converter•
Special 0:4:4 full-bandwidth chroma output•
4X over-sampling for outstanding•
resolution
Individual component gain adjustment•
EDH insertion•
Two lines output phasing•
Supports all popular CAV formats•
Selective vertical blanking•
Passive loop-through reference input,•
color black, or composite sync
Housed in the same frame with other•
8900-V audio and video modules
Supported Frame Types
GeckoFlex with 8900V-R GeckoFlex Video rear module,
Gecko video frames: 8900TX-V, 8900TF-V, 8900TFN-V
Power Rating
7.2 Watts – single slot
Input
Type: Component analog video
Connector: 75Ω BNC terminating
Format: RGB, EBU N10, Beta (US), Beta (Japan), MII
(US), MII (Japan)
Return loss: >40 dB to 5.5 MHz
Reference Input
Connector: High Z differential loop-through BNC
Return loss: >40 dB to 5.5 MHz
Output
Signal type: SMPTE 259M, 10-bit 4:2:2, 270 Mb/s
Number of outputs: Two
Connector: 75Ω BNC
Return loss: >18 dB to 270 MHz EDH embedded
Performance
Quantization: 10-bit
Internal DSP: 4X over-sampling
Frequency response: ±0.1 dB
Group delay error: <5 ns
Signal-to-noise ratio: >60 dB
Output phasing range: Up to 2.5 video lines
Phasing increment: 37 ns step
Electrical length: 2.5 µs
Operating temperature: 0° to 45°C
Relative humidity: 0% to 90% non-condensing
Indicators and Controls
Indicators:
•Inputvideopresent
•Referencepresent(2:525,625)
•Fault
•Power
Front edge controls:
•Standardselection
•Videogain
•Componentgainadjustments
•Componentblacklevel
•Inputformat
•Blanking
•Outputdelay
Remote: All indicators and controls via frame Ethernet
This module can be mounted in a GeckoFlex
frame when ordered with the 8900V-R GeckoFlex
Video rear.
8950ADC
Component video A-to-D converter
8950ADC Component A-to-D Converter
For detailed specifications, installation, and setup
instructions see:
www.grassvalley.com/docs/modular