Gravitech ARM-JTAG1 User manual

USB
ARM JTAG-ICE Debugger and Programmer
Model No.: MDUSBARMDPMINI
System requirements
Windows 98, XP, 2000 or Vista
CD-ROM drive
USB Port
Keil uVision3 IDE/Debugger Software

Driver Installation
1To install the driver, you need to install the Keil uVision3 IDE/Debugger software.
2Connect the ARM JTAG-ICE Programmer/Debugger to your PC via USB port.
Windows will detect a new hardware.

Windows will automatically install the driver for device.

Hardware Configuration
1. Hardware Configuration is the basal setting to configure the ARM JTAG-ICE
Programmer/Debugger, this section dose not include usage of uVision3 IDE/Debugger
software.
Run the Keil uvision3 IDE/Debugger software:
2Open a project:

Now, ARM JTAG-ICE Debugger/Programmer is ready to be used.

Debugging and Programming
1. Connect the ARM JTAG-ICE Debugger/Programmer to the Host PC.
2. Connect the ARM JTAG-ICE Debugger/Programmer to your target board ARM JTAG
interface.
3. Power up your target board.
4. Run the Keil uVision3 IDE/Debugger software.
5. Open a project (Example: MDFLY ARM LPC2013 Development board and sample
code).

6. Debugging:

Start Debug Session, sample code will be automatically downloaded to your target device.

7. Programming:
If you want to download the sample code to your target board device, you need to stop
the debug session first.