Great day LP500 HD User manual

PAGE 1 OF 2
LOAD-A-PUP
HUNTING DOG
MODEL: LP500 HD
READ ALL INSTRUCTIONS BEFORE USING THE LOAD-A-PUP HD
NOTE: Failure to read instru tions before use ould result in injury or death.
NOTE: All initial installation adjustments to the LOAD-A-PUP HD should be made prior to laun hing
boat.
Instructions for Installation and Use:
FIG. 1
Contents:
1-Safety Strap
2-J-bolts
2- 5/16’’ Wing nobs
2-Quic -clip pins
2-Leveling tubes
1-Load-A-Pup HD (fully
assembled)
Step 1. Select side of transom (or side of
boat) to mount Load-a-Pup HD.
Step 2. Insert J-bolt through vertical
square tube of frame to determine
desired height of Load-a- Pup HD.
(Usually, this would be done to position
platform at or just below water level)
SEE FIG. 1

FIG. 2
FIG. 3
LOAD-A-PUP HD IS NOT DESIGNED OR APPRO ED FOR HUMAN USE
NE ER USE THIS PRODUCT FOR ANYTHING OTHER THAN INTENDED USE
DO NOT USE THIS PRODUCT IN EXTREME WEATHER CONDITIONS i.e., LIGHTNING, HIGH
WINDS, ROUGH/CHOPPY WATER
MAXIMUM WEIGHT CAPACITY IS 200 LBS.
MAKE SURE THAT SAFETY STRAP IS ALWAYS ATTACHED TO PRE ENT PRODUCT LOSS
*Do not allow dog on platform while boat is moving
*Do not use on boats less than 14 feet in length
*Sides of boats must be 15 inches tall or taller
*Do not use on a canoe or pirogue
*Do not use as a diving platform
*Do not use as hunting stand
*Remove unit from boat before traveling
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282
* [phone] * www.greatdayinc.com
Step 3. Insert Leveling
Tubes Into Platform &
Quic Pin Into Position To
Hold Platform At Desired
Angle. SEE FIG. 2
Step 4. Install safety strap
to top of frame of the
Load-a-Pup HD and
connect to any available
brace or hand-hold of boat
to prevent accidental
dropping of the Load-a-
Pup HD. SEE FIG. 3