GREAT OPENINGS DMEX00100 User manual

1⁄4” RachetLevel #2 Phillips
Level The Tower
1. Remove the bottom drawer as shown below and open the coat
door to access the four leveling glides.Using a 1/4” ratchet
wrench, turn each leveling glide clockwise to raise, and counter-
clockwise to lower the glide.
2. Engage the disconnect lever on each slide by pressing down on
one, up on the other. Pull the drawer directly outwards.
3.Theslidememberthat’sattachedtothecabinethasaball
bearing carriage; position that carriage all the way forward
(failure to do so can result in slide failure). Carefully position the
drawer so that the outer and inner slide members are aligned.
Gently push the drawer straight in, and cycle once to fully
engage.
T20 Torx
DMEX00100 - REV. B | WARDROBE TOWER & PEDESTAL TOWER INSTALLATION INSTRUCTIONS
Page 1 of 2

After leveling the cabinet, examine the gaps between the doors and the cabinet. If the gaps are uneven, the doors
need to be adjusted.
1. Vertical Gaps: To improve the vertical
gap, adjust the Phillips screw.
Tightening the screw will pull the
door toward the center of the cabinet.
Loosening the screw will pull the door
toward the outside edge.
2. Horizontal Gaps: To improve
horizontal gap, loosen the Torx
screws only enough to slide the
hinges. Do not remove the screws
completely. Carefully slide the doors
up or down until the horizontal gap is
uniform. When properly aligned,
tighten the screws.
Adjust the Door Hinges
Torx screws
adjusts horizontal
gap
Phillips screw
adjusts vertical
gap
3. Side Gaps: To improve the door gap at
the side of the cabinet, loosen the side
gap Phillips hinge screw and slide the
hinge back to close the gap, or forward
to increase the gap. Do not remove the
screw.Tightenwhennished.
Phillips screw
adjusts side
gap
Page 2 of 2