GREAT OPENINGS LTSX00020 User manual

non-marring hammer Page 1 of 2
Drawer Removal
1. Fully extend drawer. While lifting on drawer front, tap down
on slide using a non-marring hammer. When drawer is free
from slide detent, rotate up and out.
2. First, ensure all slides are fully recessed into cabinet.
Remove interlock cable from left side of cabinet. Starting at
bottom of cabinet, pull cable away from slide to disengage.
Slide Removal
3. Once cable is disengaged, fully extend drawer slide.
Twist slide toward center of cabinet while tapping up near
cabinet front with non-marring hammer. Once front of slide
releases, pull slide straight out to remove.
Disengage
cable at
bottom rst
Fully
extend
drawer
LTSX00020 - REV. B | LATERAL DRAWER SLIDE REMOVAL/REPLACEMENT

Page 2 of 2
Slide Installation
1. Insert new slide into rear connecting slot.
2. Line up slide bayonet with slot in front channel. When you
install slide in front channel, you will feel it “snap” into place.
3. First, ensure all slides are fully recessed into cabinet. Starting
with the top slide, push the interlock cable back into each
slide until it clicks in place.
4. Check functions of interlock system by attempting to extend
more than one left-hand slide at a time. Only one slide should
extend at a time.
WARNING: Failure to ensure proper function of interlock
system can cause severe injury.
Drawer Installation
5. Starting with the lowest position, fully extend 1 set of slides.
Position raised bin slots over slide tabs and press down until
fully seated.