Gree LE60-13/C1 User manual

Owner's Manual
Original Instructions
RF Remote Controller LE60-13/C1

To Users
Thank you for selecting Gree’s product. Please read this instruction manual
carefully before installing and using the product, so as to master and correctly use the
product. In order to guide you to correctly install and use our product and achieve
expected operating effect, we hereby instruct as below:
(1) This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsibility for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
(2) This instruction manual is a universal one. Some functions are only
applicable to particular product. All the illustrations and information in the
instruction manual are only for reference, and control interface should be
subject to actual operation.
(3) All the illustrations and information in the instruction manual are only for
reference. In order to make the product better, we will continously conduct
improvement and innovation. If there is adjustment in the product, please
subject to actual product.
(4) If the product needs to be installed, moved or maintained, please contact
our designated dealer or local service center for professional support.

Users should not disassemble or maintain the unit by themselves,
otherwise it may cause relative damage, and our company will bear no
responsibilities.

Contents
1 Safety Notices (Please be sure to abide)...............................1
2 Installation .............................................................................2
2.1 Dimension and Component of RF Remote Controller ...................2
2.2 Installing Position and Requirements of RF Remote Controller.....4
2.3 Installation of RF Remote Controller..............................................4
3 Display Introduction...............................................................8
3.1 RF Remote Controller Appearance................................................8
4 Operation Instructions............................................................9
4.1 Matching Setting............................................................................9
4.2 Air Valve Setting.............................................................................9
4.3 Replacement of Battery in RF Remote Controller........................10

RF Remote Controller LE60-13/C1
1
1 Safety Notices (Please be sure to abide)
WARNING: If not abide them strictly, it may cause severe damage to the
unit or the people.
NOTE:If not abide them strictly, it may cause slight or medium damage to
the unit or the people.
This sign indicates that the operation must be prohibited. Improper operation
may cause severe damage ordeath to people.
This sign indicates that the items must be observed. Improper operation
may cause damage to people or property.
WARNING!
This product can’t be installed at corrosive, inflammable or explosive environment
or the place with special requirements, such as kitchen. Otherwise, it will affect the
normal operation or shorten the service life of the unit, or even cause fire hazard or
serious injury. As for above special places, please adopt special air conditioner with
anti-corrosive or anti-explosion function.

RF Remote Controller LE60-13/C1
2
2 Installation
2.1 Dimension and Component of RF Remote Controller
(Unit：mm)
Figure 2-1 Dimension of RF Remote Controller

RF Remote Controller LE60-13/C1
3
Figure 2-2 Components of RF Remote Controller

RF Remote Controller LE60-13/C1
4
Table 2.1.1 Introduction of Components
No.
①
②
③
Name
wall
3M tape
RF remote controller
Quantity
/
1
1
2.2 Installing Position and Requirements of RF Remote
Controller
(1) Please do not install the RF remote controller in the position where is wet or
is likely to be splashed with water;
(2) Please do not install the RF remote controller near high-temperature
objects or under direct sunlight;
(3) The RF remote controller should only be installed indoors, and its working
temperature range is 0°C ~ 50°C .
2.3 Installation of RF Remote Controller
Fix it by 3M tape on the wall as shown by the figure as below. The brief
instruction is as below:
(1) Do not install the button battery before installation;
(2) Use a tool to gently open the clasp, and then remove the RF remote
controller in the direction of the arrow；
(3) Use tools to conduct the DIP switch code for RF remote controller
according to room number. Please refer to the schematic diagram of DIP
switch code of RF remote controller for the detailed method;

RF Remote Controller LE60-13/C1
5
(4) Install the button battery at the buttery holder. Please note that the positive
and negative poles should be connected correctly;
(5) Buckle RF remote controller and the base together;
(6) Tear off one side of 3M tape and then stick it at the back of RF remote
controller correctly; tear off the other side of 3M tape and then stick the
mounting plate on the wall, and then the installation is finished.

RF Remote Controller LE60-13/C1
6
The black part is the rod, when the rod is close to ON, it’s ON, and the opposite
direction is OFF.
Figure 2-3 Schematic Diagram of DIP Switch Code of RF Remote Controller

RF Remote Controller LE60-13/C1
7
Figure 2-4 Sketch Map for Installation of RF Remote Controller

RF Remote Controller LE60-13/C1
8
3 Display Introduction
3.1 RF Remote Controller Appearance
Figure 3-1 RF Remote Controller Appearance
Table 3.1.1 RF Remote Controller Appearance Instruction
No.
Name
Instruction
1
“ON”button
The air valve at the current area is allowed to be open
2
“OFF”button
Close the air valve at the current area
3
Green indicator
RF remote controller status indicator
4
Red indicator

RF Remote Controller LE60-13/C1
9
4 Operation Instructions
4.1 Matching Setting
When using RF remote controller for the first time, please conduct the matching
with the zone control system. Matching method: turn on match mode of wired remote
controller and press “ON”and “OFF”buttons at the same time for 5s; when green
indicator and red indicator are on and off alternatively, it indicates RF remote
controller has entered into the match mode.
When entering into match mode, if matching is not succeeded within 5min, the
red indicator will flash quickly for 10s and then exit from the match mode. If matching
is succeeded, the green indicator will flash quickly for 10s and then exit from the
match mode.
Table 4.1.1 RF Remote Controller Match Status
Match status
Indicator status
Matching
green indicator and red indicator are on and off alternatively
Match successful
green indicator will flash quickly
Match failed
red indicator will flash quickly
4.2 Air Valve Setting
RF remote controller can open or close the air valve at current area. Press “ON”
button and then the green indicator will flash once and the air valve at current area
will open; press “OFF”button and then the red indicator will flash once and the air
valve at current area will close.

RF Remote Controller LE60-13/C1
10
NOTE!
When operating the RF remote controller, make sure it is within the receiving
range of the zone control interface.
4.3 Replacement of Battery in RF Remote Controller
(1) Use a tool to gently open the clasp, and then remove the RF remote
controller in the direction of the arrow;
(2) Take out old battery;
(3) Install the button battery (CR2450) at the buttery holder. Please note that
the positive and negative poles should be connected correctly;
(4) Buckle RF remote controller and the base together.
Figure 4-1 Replacement of battery in RF remote controller

RF Remote Controller LE60-13/C1
11
NOTES!
(1) Do not use the wrong type of battery when replacing the battery, otherwise
the RF remote controller may be damaged;
(2) If the RF remote controller does not work properly, please remove the
battery and reinstall it after 10s. If it still does not work normally, please
replace the battery.
WARNING!
Do not ingest the battery, Chemical Burn Hazard.
(The remote control supplied with) This product contains a coin/button cell
battery. If the coin/button cell battery is swallowed, it can cause severe internal burns
in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.