Green Brook WNBP-C User manual

WEATHERPROOF PROTECTION
IP44
WEATHERPROOF
SWITCHES
• Simpl to install
• D sign d for damp, dusty and dirty
nvironm nts
• Rat d to IP44
• Conforms to BS EN 60529
These GreenBrook Weatherproof
Switches are designed specifically for
use where damp or dusty conditions
may e encountered.
Engineered to perform in dirty environ-
ments, in industry, farms, gardens,
eside swimming pools, indeed wher-
ever exposure to dust or splashing
water may e encountered.
These tough, dura le items are easily
installed. The switches are protected to
IP44 standard. The units are injection
moulded in polycar onate ensuring
high resistance to impact in extremes
of temperature.
1. This product should e installed y
a competent person (e.g. qualified
electrician) in accordance with these
instructions and in compliance with
the appropriate clauses of the
current edition of the IEE Wiring
Regulations.
2. The electrical supply must e
disconnected prior to installation or
maintenance.
3. Where metal conduit is used, earth
continuity must e maintained with
the use of a suita le earth link.
SAFETY
INSTALLATION
GUIDE
STEP 1.
WARRANTY BECOMES INVALID IF I.P.
RATING IS NOT MAINTAINED.
1. The mounting surface must e flat
MODEL NUMBERS: WNBP-C,
WNSW-C, WNSW2G-C & WNSWDP-C

PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
E. sales@green rook.co.uk
W W W. G R E E N B R O O K . C O . U K
Issue No: 701451
and free from grease, dirt or loose
material.
2. Ascertain the required position for
the unit. Remove rocker switch plate
(grey) y inserting a small flat
laded screwdriver either side of the
switch and lever off. Unscrew the 2
screws and remove the switch cover
there y exposing the switch module.
Remove the switch module y
pulling firmly.
3. Using the pre-drilled holes in the
ase unit, screw the ase unit into
the required position.
4.20mm compression glands for ca le
entry to switch units should e used
to maintain IP rating.
5. These switches have screwless
terminals and are intended for use
with solid conductors.
NOTE: Th s switch s us scr wl ss
t rminals
6. Strip ack 13mm of insulation from
each wire and push lengths fully into
appropriate terminals. Ensure earth
conductor is sleeved with green /
yellow sleeving and secured to the
earth terminal.
7. Once the unit has een wired, re-fit
the switch module to the ase unit
and re-secure the switch cover.
Tighten with the 2screws.
8. Push rocker switch plate (grey) ack
into position ensuring correct
orientation.
9.Do not us solv nts or acids to
cl an th box as th s may attack
th plastic us d. The exterior should
e cleaned only y using a mild
solution of detergent and warm
water.
WARNING
DISCONNECT THE MAINS SUPPLY
BEFORE COMMENCING ANY WORK