Green-Qube Quick-Qube V User manual

Find us onSubscribe for your chance to WIN! www.green-qube.com/sign-up3m x 3m
Quick-Qube
QQ300
WWW.GREEN-QUBE.COM

Quick-Qube 300 [QQ300]Assembly Instructions forDrag the frame outwards so it is fully extended and you hear a ‘click'.WWW.GREEN-QUBE.COM1Next add the top hanging bars, you will have a combination of:2
For each Outer Support Pole insert the crook end into the central slot.Then match the hole at the other end of the Outer Support Pole to the hole in the corner of the frame.Grab a screw driver and use one of the screws to fix into place.Next take the 2 Cross Support Poles and slot each of the crooks into the central and side slots. Finally add the hanging bars in position.4 Outer Support Bars8 Hanging Bars2 Cross Support Bars

WWW.GREEN-QUBE.COMAfter one leg is done, select the diagonal leg and repeat. Then continue with the remaining two legs. You can then raise the legs up to the full height by revisiting each leg and extending the legs up further.Click to the 4th notch for the full 2.2m height or the 3rd notch for 2m.Select one leg and extend it downwards by pulling the green ring out and pushing the upper frame leg up. Just extend to the first notch to start with. 5Then slid the base under the frame.4Unwrap the outer shell and place the roof over the top of the frame.3
TIP: If you have a helper then follow the above, each taking a diagonal leg and extending at the same time.

Decrease the amount of light glare into your room and increase your tent’s invisibility with the LightSaver®.Locate the set of white or metal small rods & insert into triangular pockets both sides of each of the vent flaps:WWW.GREEN-QUBE.COMLightSaver®Finally wrap the outer shell around the frame, zipping it together as you go.You are now finished!6
Why not watch our Assembly Video?Visit www.green-qube.com/videos