Controller Multi-Zone 2,4G LED Strip
RGB Remote Control 12-24VDC ►
216/432W
Product description
The 2.4G 8 zone RGB+CCT remote control is an
universal body touch controller, which adopts the
most advance PWM (Pulse Width Modulation)
control technology, it can control all kinds of 12-
24Vdc LED lighting products, for example: LED
module, LED strips, LED light box, LED light source,
etc. Users can choose different kinds of dynamic and
colour models, adjust brightness, colour
temperature, speed, etc. Models include flash effect,
strobe effect, fade effect and so on.
Technical parameters
Working temperature: -20 to 55 Celsius degrees
Supply voltage: 12-24Vdc
Output: 5 channels
Connection mode: common anode
Controller size: 85x45x23mm
Remote size: 157x53x18mm
Static power consumption: <1W
Output current <4A/Channel
Output power: 12V:240W – 24V/480W
Function
This RF remote control can control the light through
obstacles even do not direct to the receiver.
It can control the light within 20 – 30 meters in open
area.
It can smoothly change the brightness of light and
speed of dynamic models through the switch button
on the remote control.
Operation method
Connect the load wire at first, following by the
power line, please confirm no short circuit between
connecting wire before you turn on the power.
Only the ON button can work when you turn off the
controller, it can remember the last mode you save
when you turn on it again. Which means memory
function.
Multi zone instruction:
Match code:
Connect the power at first, then press the X (X=1, 2,
3…8) zone On button 3 times within 8 seconds, when
the output LED light flash 3 times slowly, means
match code success. Every zone match code and
control separately, for example, match receiver A to
zone 1, then zone 1 control receiver A, match
receiver B to zone 2, then zone 2 control receiver B
and so on, master ON/OFF control them all.
Clean code:
If you want to change the zone combination, the link
between remote and receiver can be cleaned. Then
rebuild the link as required.
Connect the power again, then press the X(X=1, 2,
3…8 zone) group ON button 3 times within 8
seconds, when the LED light flash 9 times quickly,
means clean code success.
