Griffin Technology LK-518B User manual

www.Griffin-Stands.com
Guitar Amp Tilt
Back Floor
Stand
www.Griffin-Stands.com
www.Griffin-Stands.com
Griffin™stands and accessories are manufactured
in several innovative factories responsible for
developing products that address the newest
needs and trends of the current market. We take
pride in the Griffin™brand and endeavor to be on
the forefront of the musical stands and musical
and lighting accessories market.
Performance Issue, Uneven or Unstable- Make
sure all nuts and bolts are tight on the product. If they
are, then loosen all nuts and bolts 1 full turn counter-
clockwise, then go back and tighten each bolt only ½
turn tight. Then do a final tighten turn for another ½
turn tight. Next, Make sure there are not any missing
nuts or bolts. Third, ensure all parts on the product
are not broken or defective. Finally, Re-read the
assembly instructions or watch the product
demonstration video to ensure you have correctly
assembled or are using the product properly with
factory specifications.
Missing Parts- The pictures, videos and images
shown in this manual might have changed style or
count due to the product being redesigned. So in rare
cases the part may no longer be included or of a
different style. However, if you think you are missing
a part that is necessary to the assembly and use of
your product, then first carefully double check all
packaging for any parts you think are missing. Some
parts might be hiding in the packaging or loose in an
inner box.
User Manual
M o d e l # L K - 518B
Griffin | 11408 Hwy 64 W, Tyler, TX 75704 |
[e-mail] | www.Griffin-
Stands.com
For current product specifications, please to go
www.griffin-stands.com and type the model number
into the search bar. Locate the product listing to view
the current factory specifications. Thank you for purchasing the Guitar Amp Tilt Back
Floor Stand. Your product comes with a 1 year factory
warranty from purchase date. Please read all
assembly instructions prior to assembling your new
cart. Pictures that may aid in assembly can be found
by going to www.griffin-stands.com and typing LK-
518B into the search bar.

Step 4 –As seen in FIGURE 4, loosen knob D to adjust the
pitch of your stand. Line up the teeth to the corresponding
slot, then retighten knob D when you are satisfied with the
adjustment of your stand.
Step 1 –Loosen
knob A and extend
back leg to a
minimum of 16
inches as seen in
FIGURE 1.
Step 2 –As seen in FIGURE 2, loosen knob B, pull the
locking pin Cout and insert the height adjustment pole
to the highest setting. Reset pin Cand tighten knob B.
This is the same process used for height adjustment
after stand assembly is complete.
Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.Griffin-Stands.com/Videos
Step 3 –Attach the side rails using the supplied bolts,
washers and nuts as seen in FIGURE 3. We have included
an Allen wrench. Nuts require a 10mm or an adjustable
(Crescent) wrench. The washer goes between the steel
frame and the nut. Attach the protective foam pads to the
side rails to help prevent scuffs to your equipment.
Step 5 –For safety reasons, please always make sure to
test the stability and safety of the product before use.
Double check all nuts and bolts, knobs and connectors,
make sure that these are tight and securely fastened
before use of your product. Test the product under light
use or light loads the first time to confirm assembly and
structure of the product is correct