Introduction
Generating a fast-cutting 22,000 revolutions per
minute, this professional quality die grinder comes
complete with five 1⁄8" and five 1⁄4" shank mounted
stones in an assortment of shapes and grits for
most grinding chores. Fitted in a molded high-
impact plastic case, this powerful grinder also
includes two changing wrenches.
Inventory
A. Die Grinder ................................................. 1
B. 1⁄4" NPT Air Fitting ....................................... 1
C. Collet Wrenches ......................................... 2
D. Mounted Stones ...................................... 10
E. Wrench Set ................................................. 1
MODEL G5343
1⁄8" & 1⁄4"
AIR DIE GRINDER KIT
INSTRUCTION SHEET
Figure 1. Model G5343.
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © APRIL, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8125 PRINTED IN TAIWAN
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
Only use cutters rated for
22,000 RPM or less!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
Operation
Insert your 1⁄8" tool bit into the collet and tighten
with the collet wrenches provided. Change the
collet by removing the collet nut with the wrench
set. Connect the air fitting to the die grinder and
then to your regulated air source.
This micro die grinder MUST have 3-4 drops of oil
directly dropped into the air fitting before each use
as shown in Figure 2.
RESPIRATORY HAZARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
