Introduction
This 11,000 RPM Angle Grinder features a large
paddle switch with safety mechanism and side
handle for super control. G5786 has 7⁄8" arbor.
Includes two wrenches. Weighs 5 lbs.
Inventory
A. 5" Air Angle Grinder ................................... 1
B. Handle ........................................................ 1
C. Flat Wrench ................................................ 1
D. Pin Wrench ................................................. 1
Operation
Tool requires 90 PSI and 1⁄4" NPT air fitting to
operate correctly.
Make sure grinding wheel is backed by flange and
tightened securely with the flange nut.
MODEL G5786
5" AIR ANGLE
GRINDER
INSTRUCTION SHEET
Figure 1. Model G5786.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8032 PRINTED IN TAIWAN
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
RESPIRATORY HAZARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
EXPLOSION HAZARD!
Never exceed 120 PSI!
Always use accessories
with correct speed rating.
Angle Grinder MUST have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in Figure 2.
Grinding Wheels
Model H4790 ........................................... 5 x 1⁄8"
Model H4791 ........................................... 5 x 1⁄4"
