GRNLITE Batten 3-54 User manual

GRN Baen 3-54 v5.4
GRNlite.com
GRN Baen 3-54
User Manual
v5.4

GRN Baen 3-54 v5.4
GRNlite.com

Warnings .........................................................................................................1
About the GRN Baen 3-54 ............................................................................2
Power input and Voltage adjustment ..............................................................3
Data input .......................................................................................................4
Fixture Placement, Hanging & Maintenance ...................................................5
Fixture Menu Opons .....................................................................................6
Cell Conguraon for DMX Channel Modes....................................................7
DMX Channel Mode Break down ...............................................................8-11
Technical Specicaons.................................................................................12
Menu Tree ....................................................................................................13

GRN Baen 3-54 v5.4
GRNlite.com
WARNING: This xture is intended for use by qualied personnel only
 Always disconnect xture from AC power before aempng any service .
 For use only with electrical power that meets all local and naonal codes.
 Fixture must be electrically grounded. Do not aempt to operate this xture without a
proper electrical ground!
 Fixture is rated IP22 and is for indoor use only.
 This xture produces intense opcal radiaon which can damage the rena permanently.
Use extreme cauon when servicing the xture or when in close proximity to the powered
xture. Never look directly into the front of the xture when it is connected to electrical
power!
 Do not aempt to modify the xture or add unapproved lenses, ngs, or other electronic
devices.
 This xture should not be operated in ambient temperatures above 104ºF (40ºC)
 The xture must have a minimum clearance of six inches from the surface of the xture.
Never aempt to wrap the xture with any covering, or aempt any cosmec modicaon
of the xture.
 The xture has no user serviceable parts.
Page 1

GRN Baen 3-54 v5.4
GRNlite.com
GRN Baen 3-54
The GRN Batten 3-54 is a high performance LED fixture that gives a multitude of advantages unique to
LED technology. The RGBAW LEDs give a much wider color gamut than the usual RGB systems, and
with dramatically increased power efficiency over older technologies like Quartz lamps. The LED
fixtures eliminate the need for dimmers, gels, and large mains power feeds.
Page 2

GRN Baen 3-54 v5.4
GRNlite.com
Power Input
The GRN Baen 3-54 uses a Neutrik PowerCon inlet rated at 20A, 250V as standard. The Fixture will
operate at 120VAC or 220VAC See below for voltage adjustment instrucons.
NOTE: Disconnect power before adjusng the input voltage
Fuse – 4A, 250V Fuse must be replaced with the proper type and rang
Page 3
- Open the boom of the xture to expose the Power supply
-Remove Yoke
-Remove 4 screws on plasc end caps
-Remove 6 screws on boom cover plate
To Adjust your input voltage
- Insert a small screwdriver or similar tool through the PCU grate and toggle the switch making note of
the posion in relaon to the yellow voltage scker. If the scker is missing toggle switch to the le
posion for 110v and to the right posion for 220V

GRN Baen 3-54 v5.4
GRNlite.com
Data Input
The xture uses standard DMX and has a 3-pin XLR for DMX data input and thru.
The Data connecons for 3 pin XLR are as follows:
Pin 1 = GND/Shield
Pin 2 = Data (-)
Pin 3 = Data (+)
Adapng a 5-pin XLR data feed to 3-pin XLR is as follows:
5-pin XLR 3-pin XLR
Pin 1 - Pin 1
Pin 2 - Pin 2
Pin 3 - Pin 3
Pin 4 - N/C
Pin 5 - N/C
Page 4

GRN Baen 3-54 v5.4
GRNlite.com
Fixture placement & hanging
The xture uses a special yoke/stand for aachments. Special brackets for aaching half-couplers and
pipe clamps are also available. Half-couplers or Pipe clamps should be used for hanging the xture from
standard truss. The built-in ground support should be weighted for added stability. The yoke clutches
should be loosened (rotate handle counter clockwise) before aempng to rotate the xture in the
yoke. Rotate the clutch handle clockwise to reghten.
A safety cable should be used for every xture other than those that use ground support.
NOTE: The GRN Baen xtures may be mounted in any orientaon as long as the aachment is secure.
Allow a minimum of 3-inches of clearance from all xture surfaces to insure adequate airow.
Maintenance
There is no standard maintenance required for the GRN Baen xture. Even though all hardware is
secured with threadlocker or locking hardware, it is always a good idea to look for any loose or missing
hardware and ghten or replace as needed.
NOTE: All repairs of electronic or structural issues should be done by qualied personnel.
Page 5

GRN Baen 3-54 v5.4
GRNlite.com
Fixture Menu opons
NOTE: Be aware that DMX is only acve in “DMX Channels” mode (when the DMX
start address is displayed) and DMX is not acve in any other mode of operaon.
Page 6
Mode Funcon
Run Mode DMX on/o, Slav = ON/O
FADE Mode Preprogrammed single fade chase, Speed adjustable only
FLOW Mode Preprogrammed ow chases 0-9, adjustable
Sound Mode Uses ambient sound to drive strobe or chase (DISABLED)
RGBAW Preprogrammed stac looks 00-25
DMX Channels Addr: 001-512, channel modes 5,9,14,15,30

GRN Baen 3-54 v5.4
GRNlite.com
Cell 1
Cell 2
Cell 3
Cell 4
Cell 5
Cell 6
The GRN Baen 3-54 has 6 cells that can be addressed individually or in various groups.
GRN Baen 3-54 cell conguraon
Page 7

GRN Baen 3-54 v5.4
GRNlite.com
Fixture Mode / DMX Channel Funcon break down
Page 8
DMX CH Cells Ch Funcon Funcon Descripon
1Red 0-255 ProporonalAll Cells
2Green 0-255 ProporonalAll Cells
3Blue 0-255 ProporonalAll Cells
4Amber 0-255 ProporonalAll Cells
5White 0-255 ProporonalAll Cells
Chs mode 5
DMX CH Cells Ch Funcon Funcon Descripon
1Red 0-255 ProporonalAll Cells
2Green 0-255 ProporonalAll Cells
3Blue 0-255 ProporonalAll Cells
4Amber 0-255 ProporonalAll Cells
5All Cells White 0-255 Proporonal
6All Cells Strobe Preprogrammed Strobes
7All Cells Strobe Speed Strobe Speed— 0-255 (0=Slowest, 255=Fastest)
8All Cells Chase Preprogrammed chases
9Chase Speed Chase Speed—0-255 (0=Slowest, 255=Fastest)All cells
Chs mode 9
NOTE: Be aware that while running the internal chases & Macros the xture may of may not be
aected by intensity control from the DMX Console.