GRNLITE Par 3-36 User manual

GRN Par 3-36 v5.9
GRNlite.com
GRN Par 3-36
User Manual
v5.9

GRN Par 3-36 v5.9
GRNlite.com

Warnings .........................................................................................................1
About the GRN Par 3-36 ..................................................................................2
Power & Data Requirements ...........................................................................3
Fixture Placement, Hanging & Maintenance ...................................................4
Fixture Menu Opons .....................................................................................5
DMX Channel Funcons ..................................................................................6
User Control Panel Illustraon ........................................................................7
Technical Specicaons...................................................................................8
Photometrics..............................................................................................9-11
Menu Tree ....................................................................................................12

GRN Par 3-36 v5.9
GRNlite.com
WARNING: This xture is intended for use by qualied personnel only
 Always disconnect xture from AC power before aempng any service.
 For use only with electrical power that meets all local and naonal codes.
 Fixture must be electrically grounded. Do not aempt to operate this xture without a
proper electrical ground!
 This xture is rated IP22 and is for indoor use only.
 This xture produces intense opcal radiaon which can damage the rena permanently.
Use extreme cauon when servicing the xture or when in close proximity to the powered
xture. Never look directly into the front of the xture when it is connected to electrical
power!
 Do not aempt to modify the xture or add unapproved lenses, ngs, or other electronic
devices.
 This xture should not be operated in ambient temperatures above 104ºF (40ºC).
 The xture must have a minimum clearance of six inches from the surface of the xture.
Never aempt to wrap the xture with any covering, or aempt any cosmec modicaon
of the xture.
 The xture has no user serviceable parts.
Page 1

GRN Par 3-36 v5.9
GRNlite.com
GRN Par 3-36
The GRN Par 3-36 is a high performance LED xture that gives a multude of advantages unique to LED
technology. The RGBW LEDs give a much wider color gamut than tradional RGB systems, in addion to
dramacally increased power eciency over older technology like Quartz lamps. The LED xtures
eliminate the need for dimmers, gels, and large mains power feeds.
Page 2

GRN Par 3-36 v5.9
GRNlite.com
Power Input
The GRN Par 3-36 uses an IEC inlet rated at 10A, 240V as standard. The xture will operate at voltages from
120VAC to 240VAC.
The power cord is a European color code type and should be connected as follows:
NOTE: Only qualied personnel should aempt to change the electrical power connector.
Fuse – 2A, 250V Fuse must be replaced with the proper type and rang.
Data Input
The xture uses standard DMX. The xture uses 3-pin XLRs for DMX data input and thru.
The Data connecons for a 3-pin XLR are as follows:
Pin 1 = GND/Shield
Pin 2 = Data (-)
Pin 3 = Data (+)
Adapng a 5-pin XLR data feed to 3-pin XLR is as follows:
5-pin XLR 3-pin XLR
Pin 1 - Pin 1
Pin 2 - Pin 2
Pin 3 - Pin 3
Pin 4 - N/C
Pin 5 - N/C
Page 3
208V
Brown – Phase 1
Blue – Phase 2
Green/Yellow – Ground
120V
Brown – Hot
Blue – Neutral
Green/Yellow – Ground

GRN Par 3-36 v5.9
GRNlite.com
Fixture placement & hanging
The xture uses a standard yoke for aachments. Half-couplers or Pipe clamps should be used for
hanging the xtures from standard truss. Ground support should be weighted stands or something
similar. The yoke clutch should be loosened (rotate counter clockwise) before aempng to rotate the
xture in the yoke. Rotate the clutch handle clockwise to reghten.
A safety cable should be used for every xture when hung. Fixtures that are used on the ground do
not need a safety.
NOTE: The GRN Par 3-36 xtures may be mounted in any orientaon as long as the aachment
is secure.
Maintenance
There is no standard maintenance required for the GRN Par 3-36 xtures. Even though all
hardware is secured with threadlocker or locking hardware, it is always a good idea to look for any loose
or missing hardware, and ghten or replace as needed. The fricon clutch on the yoke is rugged, but if
forcibly over-rotated, the clutch may be damaged. The fricon clutch should be loosened before
aempng to rotate the xture in the yoke.
NOTE: All repairs of electronic or structural issues should be done by qualied personnel.
Page 4

GRN Par 3-36 v5.9
GRNlite.com
Fixture Menu Opons
NOTE: Be aware that DMX is only acve in “ADDR” mode (when the DMX start address is displayed)
and DMX is not acve in any other mode of operaon or when programming.
Page 5
Mode Funcon Sengs
ADDR Set to any DMX channel between 1 and 507
Node Is actually Mode, used to adjust the 3 LED response modes
-Nad.0 = Instant
-Nad.1 = 300ms Fade me
-Nad.2 = 500ms Fade me
UL Select White proporonal output level only (0 =o, 15=brightest)
BL Select Blue proporonal output level only (0 =o, 15=brightest)
GL Select Green proporonal output level only (0 =o, 15=brightest)
RL Select Red proporonal output level only (0 =o, 15=brightest)
FLAS Strobe Rate (All RGBW LEDs only) (0 =slowest, 15=fastest)
FADE Select preprogrammed Color Fade (0 =slowest, 15=fastest)
CE Select preprogrammed Color Chase (0 =slowest, 15=fastest)
PR Preprogrammed Colors and Looks.
SP Controls speed of PR Programs 14-28
**Control channels 0-13 do not have speed parameters** (0 =slowest, 15=fastest)

GRN Par 3-36 v5.9
GRNlite.com
DMX Channel Funcons
The GRN Par 3-36 uses six DMX channels, and the DMX starng channel for any xture may be set to
any starng address from channel 1 to channel 507 as desired.
Channel Funcon DMX Value
1Dimmer 0-255 Proporonal
2Red 0-255 Proporonal
3Green 0-255 Proporonal
4Blue 0-255 Proporonal
5White 0-255 Proporonal
6Macro/Strobe 0-255 (See Funcon Table Below)
Channel (6) Value Macro Funcon Descripon
0-5No Eect
6-127 Strobe Eect : 6 = Slowest, 127 = Fastest
128-170 Slow Overlapping Color Chase :
R-G-B-RB-RBW-RGBW-RGW-RGBW
171-210
(171=Slow, 210=Fast)
Fading Color Chase :
R-G-B-W-RG-RB-RW-GB-GW-BW-RGB-RBW-BGW-RGW-RGBW
211-255
(211=Slow, 255=Fast)
Color Chase :
R-G-B-W-RG-RB-RW-GB-GW-BW-RGB-RBW-BGW-RGW-RGBW
Page 6

GRN Par 3-36 v5.9
GRNlite.com
GRN Par 3-36
User Controls
Page 7
NOTE: There is a lockout feature that disables the control buons. To enable the control panel, press any
control buon for 3 seconds. The display will ash once when it becomes acve. The control
buons will become inacve again 30-40 seconds aer no buons are pressed.

GRN Par 3-36 v5.9
GRNlite.com
Input Power 90V-240VAC @ 60hz
Power Connector 10A C13 IEC
Operang Current 1.2A @ 208V 60Hz; 1.4A @ 110V 60Hz
Mains Fuse 2A 250V
Weight 8 lbs (3.63 kg)
Dimensions 13” high (including yoke), 10.25” wide (including handles)
Output 6250 Lux @ 1.5 Meters (All colors on full)
Beam Spread 20° Color Mixing Lenses
LED 3 Wa RGBW LEDs:
8-Red, 12-Green, 10-Blue, 6-White
DMX Channels 6 Control Channels:
Intensity, Red, Green, Blue, White, Macro/Strobe
DMX Input / Output 3—Pin XLR in and through

Page 8