GRUPA Igram IG-PT-I User manual

The lamp is delivered fully assembled. Packaging contains the lamp
and USB-C to USB-C charging cable. Charging adapter is
not included.
Two dierent variants, I and J shape.
Grupa Studio d.o.o.
Popa Dukljanina 1
10000 Zagreb, Croatia, EU
inf[email protected]
Rated input power
Charging time
Light source
Light emission
Color temperature
Color rendering index
Degree of protection
5V DC @ 2.4A
5 h with fast charger
LED 4.2 W
358 lm
2700 K
≥ 90
IP 44
Igram
Portable Table
Lamp

(C)
(A)
(B)
Before first use, the battery in the lamp must be fully charged.
Plug the charging cable (A) into the USB-C port on the bottom of
the lamp and connect it to a power supply.
Tap the touch dimmer switch (C) to adjust light intensity.
When charging, red indicator lights (B) will appear on the lamp
base. When the lamp is fully charged the red lights will turn green.
Charging time is 5 h with fast charger (min 2.4 A).
100%Intensity
1st tap 2nd tap 3rd tap 4th tap
45% 15% OFF
8 hAutonomy 17 h 62 h
Important
The safety of this product can only be guaranteed if these instructions
are observed during use. We advise keeping these instructions. Do not
disassemble this product. This product has been carefully handmade
and due to the nature of such work please allow slight variations in the
surface of the material. Grupa declines all responsibility for products
that are modified without prior authorization.
Warning
Avoid using sharp objects as they may scratch the surface
permanently. Always pay attention to the luminaire balance, do not
place it on uneven surfaces. Regularly check that there is no damage
to parts and cable.
Battery
Battery-operated product intended for battery use only. Battery ability
to hold a charge inevitably deteriorates over time. Replaceable
lithium-ion battery can be purchased from Grupa upon request.
Low power mode
Low-battery mode is triggered when the battery charge drops to 10%.
The light intensity automatically drops to 15% of the current intensity,
and lasts up to 2 hours.
Environment
This product is for indoor and outdoor use. The lamp is resistant to
splashes, light rain and dirt. Do not immerse this product into water.
Cleaning
Powder-coated surfaces should be cleaned with aqueous solutions
made from pH-neutral detergents or cleaning products and soft,
non-abrasive cloths, rags or industrial cotton batting. Always clean
metal surfaces gently and without scrubbing so that the surface is not
scratched. Never use cleaners containing granular substances, acetic
acid or citric acid.
Disposal
Do not throw this product in regular household trash but in a proper
waste disposal.