GRUPA Igram User manual

Igram
by GRUPA
Lamp-Table
1. To assemble the Igram lamp-table screw the table top (A) onto the body (B).
2.
To turn on the lamp, tap the switch button (C) located on the horizontal arm.
Hold the switch button to adjust light intensity.
(
C)
(
A)
(
B
)

Important
The safety of this product can only be guaranteed if these
instructions are observed during use. We advise keeping these
instructions.
This luminaire must be connected to a grounding electrical system.
Always turn o power to the system before starting installation work.
Whenever acting on the luminaire (i.e. changing the light bulb),
ensure that the power supply has been switched o.
Warning
This product has been carefully handmade and due to the nature of
such work please allow slight variations in the surface of the material.
Do not use force to assemble the luminaire. Always pay attention to
the luminaire balance, do not place the table on uneven surfaces.
Do not disassemble this product. Grupa declines all responsibility for
products that are modified without prior authorization.
This product is for indoor use only. Do not immerse this product into
water.
Regularly check that there is no damage to cables and other parts. If
the external cable of this luminaire is damaged, it must be exclusively
replaced by the manufacturer or its authorized service agent or
similar qualified persons in order to avoid a hazard.
Avoid using sharp objects as they may scratch the surface
permanently. Avoid any contact with sources of heat. Do not sit or
stand on the table. Do not subject the table to strong impact.
Light Source
The product contains integrated LED light source of energy eciency
class A+.
Environment
Do not throw this product in regular household trash but in a proper
waste disposal.
Cleaning
Powder-coated surfaces should be cleaned with aqueous solutions
made from pH-neutral detergents or cleaning products and soft,
non-abrasive cloths, rags or industrial cotton batting.
Always clean metal surfaces gently and without scrubbing so that the
surface is not scratched. Never use cleaners containing granular
substances, acetic acid or citric acid.
For dusting and light cleaning of wooden and ceramic surfaces use a
soft, dry cloth. If needed, gently wipe the surfaces with soft cloth
wrung in clean water and immediately wipe the surface again with a
dry cloth.
Manufacturer:
Grupa Studio d.o.o.
Popa Dukljanina 1
10000 Zagreb, Croatia, EU
[email protected]
grupa.com
Igram
by GRUPA