Gryphon POWERALL User manual

~
16.000mAh
P
(!)
WERALL
PORTABLE
POWER
BANK
BATTERY
JUMP
STARTER
LED
FLASHLIGHT
OWNER'S MANUAL
Thank you for purchasing the Powerall. Before operating your new
device, please read this owner's manual carefully.This manual will
inform you of the Powerall's specifications and proper operation
procedures, safety warnings and other useful information.
504-0220064-08

Product Layout
Main Un it
On/Off
Button
Bright LED
Light
Accessories
Jumpstart Socket
-- Recharging Port
-- USB Output
-- Battery Indicating Lights
~- USB Output
Heavy-Duty Jump
Start Cables AC Adapter Charger DC Adapter
Charger
USB Charging Cable
Micro USB
Iphone 4 I
48
lphone 5 I 58
*Actual product and accessories mayslightly
vary from the picturesshown above.

Battery Capacity LED Indicator
Press the Power
bu
tt
on lightly to check the remaining ba
tt
ery capacity.
I
Indicator
lights
II
5
OFF
lis
Flashing
ll
1
Solid
ON
ij2soli
doN
II3Solid
oNII4Solid
oN
I
Is
solid
oN
I
I
Battery
Capacity
II
0%
II
10%
II
20%
II
40%
II
60
%
II
80
%
II
100%
I
While the Powerall is being charged, the indicator lights will flash one
by one until it's at maximum charge (All 5 indicator lights will stay on
when the Powerall is fully charged).
How to Jump Start a Vehicle Battery:
1. Make sure the battery capacity of the Powerall is above
50°
/o
(At least 3 indicator lights stay ON
).
2. Connect the jump st
ar
t cable to the drained battery of the vehicle.
Connect
red
clamp to the positive"+"terminal and black clamp
to
the negative "
-"term
inal.
3. Connect the jump start cable
to
the proper socket of the Powerall.
4. Now attempt to crank start the engine. If engine does not start,
disconnectthe jumper cables and wait at least 10 seconds before
attempting to start the engine again.
5. Disconnect the jump start cable from
the
Powerall within 10
seconds after the engine has been successfully started.
Recommended Vehicle Engine Displacements
for Jump Starting:
Gas powered
vehicles-
6.0L displacement
Diesel powered vehicl
es-
5.0L
displacement
Petrol powered vehicl
es-
6.0L displacement
&, WARNING! Do not touch the
red
and
blackclamps together
or
connectboth to the same piece
of
metal to preventphysical
injury
and
damage to the
ve
hicle.
Do
not
use the jump st
art
cable for
any
otherpurpose otherthan
jump
starting the vehicle.
KEEP
AWAY
FROM CHILDREN AT
ALL
TIMES!

How toTurn On the LED Light:
Press and hold the Power button for 3 seconds to turn on the LED
light. Once the LED light is turned on, pressing the power button will
cycle through additional modes until you press and hold the Power Button
for 3 seconds to exit the cycle and turn the LED light OFF.
Solid light
--7
Strobe light
--7
SOS flashing
t
<-
- - - - - - - - - - - - - - - - - -
-~
Charging Mobile Electronic Devices
The Powerall has two 5V USB ports and includes one USB adapter
cable with multiple types of charging adapter plugs for various
different electronic devices.
How to Charge Electronic Device:
1. Make sure the electronic device is 5V powered.
2.
Connect the USB adapter cable to one of the USB
ports on the Powerall.
3.
Plug the compatible charging adapter plug into the electronic device.
4.
Press the Power button to start charging the electronic device.
NOTE: Both USB ports can be used to charge two separate
electronic devices together at the same time. Either USB ports will
accept standard USB cables included with your electronic device.
How to Charge the Powerall:
Use only the supplied
AC
adapter orthe
DC
adapter to charge
the Powerall.
.&
WARNING!
Any other chargers may cause possible damage
and or reduce the service life of the Powerall.
Specifications
Battery Capacity: 16,000 mAh
Battery Life Cycles: >1
000
Outputs: 2 x 5V I 2.1A USB
Input: AC 100-240V , DC 14.5V I 1.5A
Jump Start Current: 600A
Dimensions: 170 x 78 x 30mm
LED Lifespan: 100,000 hours
LED Energy: 1
w
LED Lumens: 86 Lm

FAQ
Q: What are the main features of the Powerall?
A: The Powerall is mainly used to charge portable electronic devices,
such as mobile smartphones, tablets, portable gaming
systems, digital cameras, camcorders, Bluetooth headsets, portable
GPS devices, and any other DC
5V powered electronic devices. It
can also jump start a drained car battery with the supplied jump start
cables. There's also an included ultra-bright LED light that can be
used as a flash light or SOS signal flashing light.
Q: How to turn on and off the LED light?
A: Press and hold the Power button for 3 seconds to turn on the
LED light, then press the Power button to switch between different
illumination modes, press and hold the Power button again for 3 seconds
to exit the cycle and turn off the LED light.
Q: How to turn off the Powerall?
A: The Powerall has an auto turn-off feature. Once the connected
electronic device has been fully charged, the Powerall will
automatically stop charging and enter into sleep mode.
Q: How long will it take to fully charge the Powerall
to maximum capacity?
A: 3-4 hours. Depending on the current battery charge indicator.
Q: Will reversing polarityconnections of the jump start
cable damage the vehicle?
A: No, the Powerall is very safe with comprehensive protection. If you
accidentally connect the red and black cable clamps to the wrong
polarity terminal and attempt to jump start the vehicle, the fuse will be
blown and will cut the power immediately to prevent injury and avoid
damaging the vehicle.
Q: What if itdoesn'tjump start the vehicle?
A: Ifthe Powerall fails to jump start the engine, please disconnect the
jumpercables and wait at least 10 seconds before attempting to try
again. It is also highly recommended
to replace the vehicle battery once
every 2
or 3 years.
Q: How long will it take to fully charge a mobile phone?
A: Usually it will take about 2 hours as the output current can reach
2.1
A, which is much faster than the original factory chargers that are
usually supplied with the mobile phone.

Q: How many times can the Powera/1 jump starta vehicle?
A: Approximately 20 times with a 100°/o fully charged battery. Results
may vary depending on owner usage and vehicle engine displacement.
Q: How long is the Powerall's standby time?
A: The typical standby time of the Powerall is 3 months fully charged.
It is recommended to charge the Powerall once every 3 months to
prolong its service life. Results may vary depending on owner usage.
~ Safety Warnings
Failure to obey the safety warnings may result in electrical fire,
electricalshock and damage to your vehicle.
1. Do NOT throw or apply physical shock to the product and NEVER
attempt to disassemble the product. Keep the product away from fire,
heat, and water. Use only the supplied
AC adapter and DC adapter
to charge the product. If the product appears abnormal in shape,
immediately stop usage and disconnect all electronic devices.
2. Keep the product away from children at all times. The product is
NOT a toy for children to play with.
3. Never allow the cable clamps to touch each other or connect to
the same piece of metal to prevent physical injury and damage
to the vehicle.
Trouble Shooting
I Problem II Cause I
L__l __ S_o_lu_ti_on ___ _J
The 5 indicator lights of The Powerall is at.about 60% Unplug the charging
the Powerall are turned battery capacity due to long adapter, and re-plug it
on while charging, but the term storage without use. back into the recharging
Powerall is NOT at maxi- port (DC 14.5V input port).
mum battery capacity.
There is no response when The Low Voltage Protection Plug the charging adapter
pressing the Power button is activated and the electronic into the recharging port (DC
on the Powerall. circuit has been shut off. 14.5V input port) to activate
the electronic circuit.
The battery drains very The battery requires a full Perform a full battery drain
quickly on the first use charge prior to use. and charge for a full 12
out of the box. hours without use.

Protection +
I
_ ...
Over Current Short Circuit Overload
Protection Over-Voltage Over-Charge Protection Protection Protection Protection
Toxic and Harmful Substances
Composition and amount of toxic and
harmful substances in the Powerall
Pb Hg Cd
Cr (VI)
PBS
PBDE
0 0 0 0 0 0
o : Indicates all homogeneous materials' hazardous substances content
~
®
@)
Q
Q
Q
Q
•
•
•
•
•
are below the MCV limit specified in the Standard 2002/95/EC(RoHs).
The product should NOT be submerged
in water, exposed to rain ormoisture.
Do NOTallow the product or accessories to get wet when
in use orstorage.
Do
NOT modify or disassemble the product.
Keep the product away
and out of the reach of children at all times.
Do
NOT expose the product to fire or intense heat as it may explode.
Do
NOT reverse polarity connections.
Do
NOT throw or apply physical shock to the product.
Keep the product away from all combustible materials such as carpet
when the product is being used.
Only charge the product
at temperatures between 32°F to 140° F.
Only charge the product using the supplied charging adapters.
Ifthere are any problems with the product or malfunction occurs during
usage, immediately stop operation.
If corrosive liquid seeps from the product and comes
in contact with your eyes ,
immediately wash your eyes with running water and consultwith a doctor.
If corrosi
ve liquid seeps from the product and comes in contact with your
skin, immediately wash thoroughly with soap and wate
r.
cEre ~ Q ~ ® cEc

Terms of Standard Limited Warranty (Non-Transferable)
Gryphon Mobile Electronics, LLC (Gryphon) warrants
to the original retail purchaser
thatthe Powerall purchased from a Gryphon authorized retailer are free from defects
in materials
or workmanship under normal use and conditions for a period of one (1)
year from the date of retail purchase. Accessories, charge adapters,
AC adapter and
DC adapter, and
jump start cable are warranted for a period of thirty (30) days from
the date of retail purchase. A sales receipt with product serial number(s) and date of
purchase are required
to verify proof of purchase. To activate the one (1) year Limited
Warranty coverage you are required to complete the registration portion
of the warranty
card and mail along with proof of purchase to Gryphon Mobile Electronics, LLC. Address;
2664 Saturn Street. #8, Brea, CA 92821 within thirty (30) days from the date of retail
purchase. Failure to complete the warranty registration card and return to Gryphon in the
time specified
in this document will limit the warranty of the product to only a maximum of
thirty (30) days from the date of retail purchase.
Should the product be determined defective during the applicable warranty period,
the defective product will be repaired or replaced with a reconditioned product, at the
sole discretion
of Gryphon. To obtain warranty service, the product must be returned to
Gryphon along with proof of warranty coverage.
This Limited Warranty will not cover the following:
• The Limited Warranty is only for the original purchaser ofthe product and is not transferable.
• This Limited Warranty will only cover the product and does not cover accessories supplied
with the product.
• Any and all damages to electronic devices and any other personal property.
• Any and all cosmetic damages and/or damages due
to negligence, misuse, abuse, failure
to follow operating instructions, accidental spills orcustomer applied cleaners.
• Any and all damages or loss due to environmental causes such as floods, airborne fallout,
chemicals, salt, hail, windstorms, lightning, or extreme temperatures.
• Any and all damages or loss due
to accidents, road hazards, fire, theft, or vandalism.
• Any and all damages due to improper installation
or connection, improper connection to
equipment of another manufacturer, modifications
of existing equipment, faulty usage,
improper cleaning of the product.
• Any and all product(s) that have been opened, tampered with, serial number and/or "QC"
label removed, erased, defaced,
or altered in any way for any reason or which have been
damaged due to alteration
or service performed by anyone other than Gryphon.
No other warranties expressed or implied
Except as expressly set forth in this Limited Warranty, Gryphon makes no other warran-
ties, expressed
or implied, including any implied warranties of merchantability and fitness
for a particular purpose. Gryphon expressly disclaims all warranties not stated in this
Limited Warranty. Any implied warranties that may be imposed by law are limited to the
terms of this expressed Limited Warranty.
-X-------------------------------------------------
Customer &Product Information
Name I Tel.
I
Address
Email
Serial No.
Purchase From lDate
of PurchaseI

Disconnect
the
jumper
cables
from
the
battery
once
the
engine has started.
If
you leave
the
jumper
cables
permanently
connected
for
extended periods
of
time,
this may cause damage
to
the
jumper
cable
and
I
or
the power
pack
device.
Never touch the
red
and
black
clamps
together
or
connect
both
clamps
to
the
same piece
of
metal
as
this could cause
physical
injury
to
both
you
and
your
vehicle.
505-1
001
001.()1