gtt systems GTTS-3000 VMS User manual
1
GTTS-3000 VMS
micro SIM Card + backup battery
installation
Rev 1.0 Date: 11-07-2014
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
2
Use an Allen key screw driver to remove the 4 (2 on each side)
screws that are holding the cap in its place.
Preserve these 4 spacers to reassemble the unit (right image).
Unscrew the 4 imbus screws to remove the cap
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
3
Use a Philips head screw driver to remove the 4 screws that hold the cover in
place.
Then lift the cover to the side as shown in the bottom right image and
disconnect the battery by pulling the 3wire plug from the leads.
Remove the 4 Philips screws
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
4
Insert the micro SIM Card in its socket as shown in the image below.
Put the micro SIM Card in its place
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
5
Connect the battery as shown in the image below.
Connect the battery
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
6
1. Place the cover back on to the bottom halve of the box
2. Tighten the 4 screws that hold the cover in place
3. Place the cap on the unit using the 4 Allen key screw. Use the
spacer as shown in the bottom right image.
Reassemble the unit
GTT Systems B.V. Zweedsestraat 8A26, 7418 BG Deventer, The Netherlands T +31(0)570 606088 E [email protected]u Wwww.gtts.eu
VAT / BTW NL8204.50.558.B01 ICC / KvK 08189634 Rabobank 1198.70.142 IBAN NL48 RABO 0119 8701 42
7
If you have any comments or questions regarding this
manual. Please contact m.vlas@gtts.eu.
Comments or questions
Table of contents
