Gura Gear Bataflae 32L User manual

Welcome to the Gura Gear family.
Thank you.
Configuration
Configuring Harness System
Order of Adjustment
Un-zip harness pocket on
back of bag and pull out
harness.
Latch waist straps and
shoulder straps to base of
bag.
Latch load lifters to top of
bag. Then the harness is
ready.
To properly fit bag, adjust
straps in the order shown.
Waist Belt
Hip Loaders
Shoulder Straps
Load Lifters
Sternum Strap
Full Opening
Butterfly Opening
4
5
2
1
3
4
5
2
1
3
Leave top buckle connected
Pull zipper to bottom middle
Open butterfly panel to access your gear
2
1
3
Disconnect top buckle
Pull zippers to bottom corners
Open full panel to access your gear
2
1
3
2
3
3
1
1
2
We are here to help
[phone] or [email protected]
Gura Gear
154 East 21st Street Ogden, Utah 84401 United States
www.guragear.com

Waist Strap Removal
& Adjustment
2
1
Unbuckle both hip loaders.
Detach from velco backing,
pull strap out to remove or
shift up or down for ideal fit.
2
2
1Place leg(s) of tripod into right-side pouch. Use
accessory strap around the top of the tripod to
secure it to the bag.
Wrap one end of accessory strap around the leg
of the tripod. Attach other end of the strap to
the bag as shown. Repeat for other side.
Thread provided Kooh Cord through bottom
handle loop and then around legs of tripod to
secure tripod to bag.
Tripod Side Mount Tripod Center Mount
Locate strap keeper. Unstrap and roll/unroll to
resize. Resecure velcro.
Rain Protection Ground Protection
Remove protective cover from zipper
pocket.
Cover bag and tighten pull cord.
Remove protective cover from zipper pocket.
Lay the cover on ground to provide dry, clean
surface to rest bag on.
2
1
1
Velcro Strap Keepers