H-KING KI-61 Operation instructions

Caution:this plane is not a toy!
Before use ,please carefully read this
manual.
Wing Span:70.8in/1800mm;Flying Weight:3500g;
Wing area:47sq.dm; Radio:4channels 4servos;
Length:52.8in/1343mm; Engine:2C 60,4C 91;

Cut the servo holes and
retractable wheel hole under
the main wing .
Dig holes on the plywood for
tri-horns assemble.
Apply AB glue to both plywood
and squares of wood.

Insert the servo in the middle
of two woods,then fix two TP
screws on each side.
Insert the servo to the prepared
servo hole then fix it with four
screws .Connect tri-horn and
servo with pushrod.
The finished picture as shown.

Bottom view of the brake wood.
The hole is used to stop the
collision to the film.
Apply instant glue as shown.
Organise retractable landing
gear as shown.

Fixup the retractable landing
gear series with four TP screws.
Apply instant glue.
Fix the wheel plywood to
the landing gear.
Assemble retractable landing
gear to the main wing.

The finished picture as shown.
Put the servo into the
hole and pull out the servo
extension from main wing.
Assemble the retractable
pushrod,then pull out it.

Find out the holes on each
sides of the fuselage as
shown.
Find out the holes on the tail
fuselage as shown.
Insert the Aluminium bolt
through the tail fuselage.
Assemble the stabilizer as shown

The finished picture as shown.
Screw the stabilizer to the
tail fuselage with one 3*12
screw on each sides.
Bend tail wheel landing gear.

Insert the tail wheel
landing gear into the
rudder.
Fixup the tail wheel to the
rudder with four TP screws.
Connect the aileron and the
stabilizer by hings, and
glue them.

Apply instant type glue
to both sides of each
hinges of the rudder.
Link the elevator servo to
the elevator with pushrod.
Use the same method to link
the rudder servo to rudder.
Assembly on the other side .