H-KING Crusader 30E User manual

Instruction Manual

1. Please read this manual carefully and follow the instructions of the manual before you use this
products.
2. Our airplane is not a toy, which is only suitable for experienced pilot. Or if you are a novice
pilot, please operate under the guidance of an experienced pilot.
3. Not recommended for children under 14 years old.
4. Please adjust this plane according to the instructions and make sure to keep your body parts
out of the rotating propeller all the time, or it may cause damage to the plane or serious injuries
to your body.
5. Do not fly in the thunderstorm, strong wind or bad weather.
6. Never fly R/C planes where there are power lines overhead, automobiles, airport, railway or
near a highway.
7. Never fly R/C planes where are crowds of people. Give yourself plenty of room for flying, as
the plane can fly at a very high speed. Remember that you are responsible for others safety.
8. Do not attempt to catch the plane when you are flying it.
9. The operator should bear full responsibility of proper operation and usage with regards to
the model. We, Hobbyking will not be responsible for any liability or loss due to improper
operation.
SAFETY INSTRUCTIONS
1

1. Install both wheel axles on the landing gear. Tightened it with the supplied nyloc-nut. Then install both
wheels on the axles. Use the supplied collar and apply loctite glue to the grub screws and lock the
wheels in place. Use the supplied screws to secure the main gear onto the fuselage as shown.
2

2. Install the aileron strips on the main wing. Apply a few drops of CA glue to secure the strips into place.
3. Install servos onto the wing servo pocket. Hook up the control linkages to the control surfaces.
Apply glue to the control horn and stick it on the aileron strip.
3

4. Install the main wing onto the fuselage. Use the supplied socket head screws to lock it into place
5. Install the elevator to the stabiliser as shown. Note: You may first align the elevator and stabiliser carefully
with minimal gaps in between the two. Once you are satisfied with the setup, apply CA glue to the hinge
and let dry.
4

6. Install the tail gear into the mounting plate as shown.
Then use the supplied screws and install the stabiliser onto the fuselage with the tail gear assemmbly
in place.
5

7. Install the vertical fin and simultaneously insert the tail wheel steering control arm into a slot on the
rudder as shown. Apply epoxy glue to the tail fin and let it dry. Note: Ensure the empennage is true and
square to the wing when install.
8. Y ou may install the rudder and elevator servos at this time. First, use a piece of tape and tape the control
surfaces to the fin/ stabiliser to ensure the control surfaces are levelled. Hook up the control linkagaes
to the pushrod adjuster and tighten it with the grub screw. Trim the excess pushrod by a wire cutter.
6

9. Install you desired brushless motor onto the motor mount as shown. The motor thrust line should be 2
degrees to the right and 2 degrees down to counteract the motor torque and pitching up when apply
power vigourously.
7

10. Done!
8

C of G
90mm from the wing's leading edge.
Recommend control throws:
Rudder: 20mm L/R
Elevator: 10mm up/down
Aileron: 8mm up/down
20mm
20mm
Rudder
10mm
10mm
Elevator
8mm
8mm
Aileron
C of G
90mm
9