1
2
1 - After water line is connected, please plug in
electrical outlet, and then:
a) Press the room temperature water button to make
sure water line is working and fill one full glass to
flush/clean filters. Then let unit sit for 5 minutes.
b) Press and hold cold water button for at least 45
seconds.
c
c) Press hot water button (first press releases safety),
then press and hold hot water for at least 45
seconds.
d
d) DO NOT TURN ON COLD & HOT POWER
SWITCHES UNTIL THE ABOVE STEPS ARE
COMPLETED. TURNING ON HOT POWER
BEFORE COMPLETING THE ABOVE STEPS WILL
TRIGGER A SAFETY MECHANISM AND DISABLE
HOT WATER TANK.
3. To dispense cold or ambient water, press the cold or ambient water button.
4. To dispense hot water, press the hot water button twice; first press to unlock the
safety, and hold it down on the second press to dispense hot water.
5. Water will stop dispensing when any of the three water buttons is held down for
more than 60 seconds. If you need more, water the let go of the button and then
press it again.
