Haas Automation OFFICE MILL User manual

OFFICE MILL
OPERATOR’S ADDENDUM
96-0198 Rev V
March 2012 © 2012 Haas Automation, Inc.

1
96-0198 Rev V
March 2012
Installation
NOTE: Use these installation recommendations with those in the
Vertical Mill Reference Manual. Information supplied here is


1. Unwrap the shipping material and lift the machine from the pallet.
 
 
 
4. Connect power and air.
 
6. Do a spindle sweep.
7. Run-in the spindle.
Lift The Machine
Refer to the Vertical Mill Reference Manual for information on machine lifting.
Install Casters (Optional)



Warning




 

 

Leveling Pads
24-1/2 (622 mm)
Pallet Jack
Pendant ArmShown
in Shipping Position
Control
Cabinet
SIDE VIEW

296-0198 Rev V
March 2012

1. Raise the leveling screws high enough to remove the leveling pads. This lowers

 
 

this is complete.

Put the pendant arm into operating position when the machine is in place.
1. Remove the four screws from the pendant arm.
2. Swing the pendant arm 90° toward the front of the machine to the operating
position.
3. Replace the pendant arm screws.



 
 
3. Remove the four screws from the pendant arm.
 
screws.
 
position and reinstall the door handles.
Remove the Shipping Brackets

 
Spindle Head Shipping Bracket
 


3
96-0198 Rev V
March 2012
 

Cable Carrier Shipping Bracket Coolant Tank Shipping Bracket

NOTE: Refer to the Vertical Mill Reference Manual for machine leveling
instructions.
. Fine leveling will not affect the cutting performance of
the mill and 


 



 

 
 
Connecting Electrical Power

 
 
 
 
 
  
 



496-0198 Rev V
March 2012
-
nects to voltage that can range from 195V to 254V.
 


 
power using a L6-20R connector. This connector has 2 power pins and a ground

L1
L2
Single-Phase Connection
Line Load
Connecting Air
CAUTION 

when it is connected to the machine.
1. Refer to the procedure given in the Installation section of the Service manual to

 



 
 
 
 

 

 



5
96-0198 Rev V
March 2012

 
 
 
 
 
 


 
 
CAUTION 




 
 
 
 

moved in the tool holder.
 
 -

 
 
 






-



the spindle.

696-0198 Rev V
March 2012
Operation

You can use HA5C indexers with AC-25 or AC-125 air collet closers, or an HRT110 or



Office Mill with HRT110 Rotary Table Office Mill with TR110 Rotary Table



Maintenance

-
dures.
Tool Changer

