Haier Commercial Cool CPRB07XC7 User manual

User Manua_
M@d÷_# CPRiB@TX¢7_ CPRB@TX¢7oB, CPRB@TX¢7oW_ CPRB@TX¢7oE
Manual d÷_ Usuar_o
P@r@ M@d÷l@ d÷ # CPRBOTX¢7_ CPRBOTX¢7oB, ¢_TX¢7°rwI CPRBOTX¢7oE
Befo_eope;x:_tingthisair conditioneb please read these in@uctions completely°

@ @
Thank you for buying a dependable, energyosaving and _sy_toooperate CommericaU Cod air conditioner.
This manual contains use@Jinformation for you to maintain, operate, in,stall and safdy use your air
conditioner. Your air conditioner deans, cools and dehumidifies the air in your room to provide you with
the ultimate Jevd of comfort. Please read instructions care@JJybefore using be product. Also, do not
forget to fiJJout and mail the P_duct Regis_ti@n Card.
@ @
Record Your Model and I Nu_bero
Attach the sales receipt to this guide and keep for future references Model and serial number can
be obtained from the serial label, which is on your air conditioner_ For dl your service calls during
the warran_ period the following information wJJJbe needed:
TABL!
R_¢E_TACLE AND FUSE TYPE_
_0 _5 _0

2)
6)
7)
81
9)
10)
Air conditioner must _ connected to proper eJectricai outlet with He correct dedricd
supply. (s_ table previous page)
Proper grounding must be ensured to reduce the risk of shock and fire. DO NOT CUT OR
REMOVE THE GROUNDING PRONG. If you do not have a three-prong elecwic:
receptacle outlet in the wall, have a certified eiectrician in4aH the proper receptacle.
The wall receptacle MUST be properly grounded.
Do not operate air conditioner if _wer cord is frayed or otherwise damaged. AJso avoid
using it if there are cracks or abrasion damage along the length or plug connector or if
the unit md_nctions or is damaged in any manner. Contact an authorized service _r
examination, repairs or adiu4ments.
DO NOT USE AN ADAPTER OR AN E_ENSlON CORD.
Do not block airflow around the air conditioner. _, the exhausthose should be free of
any obstructions.
Always unplug the air conditioner _bre servicing it or moving it.
Do.not install or use the air conditioner in any area "where the atmosphere con_ins
combustibb gases or where the atmosphere is oily or sdphurous. Avoid any chemicals
coming in conrad with your air conditioner.
Do not place any obiect on the top of the unit.
Never operate the air conditioner wi@out the fiJ_rs in pJace.
Do not useHe air conditioner near a _thtub, shower or wash basin°
t
3

• Phase keep this manual in a sa_ place.
• Do not use liquid or a spray to dean this product. Use a damp cloth.
o Do not place the product on an unstabJe surface or devoted place as it may fall and cause damage
or injury.
o Never spi,lJliquid on the control_panel; it may cause dectrical sh_k to the electronic parts inside and
disable them or cause them to function improperly.
• Never try to dismantle the product by yoursdf_ Unsupervised dismantling and incorr_t reassembly
of the inside of the back caver may damage the eJectricd circuit and affect i_ performance.
Hen maintenance is required, pJeasecontact the J_d service center or Jo.caJdistributor.
Thank you br purchasing our Commerical Cool product. Please
read this manuaJ carefuJJy before operating and store for future
reference StapJe your receipt to your manu,d. You wiJJneed it
to obtain warranty service.
Mode[ number
Seridl number
Date of purchase
3
4

1. Thismodel is easy to operate. Theelectroniccontrd panel has a timer, thermostat,three speedcoding
spas, three fan spe_s and one spe_ dehumidification function (dry).
2. Thisportable air conditioner does not require water _0 j be added.
3. Theunit hasa unique design which
thusavoiding the need to empty the
4_EasyotoqnstalJwindow kit is indudd, which consistsof the exhaust hose,2 hose adaptors, the window
panel kit and window panel adapton
5oFuJFdbectionaJcas_rs are included to help move the unit to _ conveniently usedin almost any area°
6. Thefilter screenisdesigned for easyaccessibility of the fiJtero
7. Portableair conditioners are easy to store when not in,use.
4
5

]. Contrd Pand
2. Air OutWet
(To be opened manually]
3. Handle Hole
4_ Caster
5. Air Filter
6. Air OutJet (Heat Exhaust_
7. Air intake (Condenser)
8. Remote Contrd Storage FaciJi?
9. Water OutJet Drain
10. Power Supply Cord
2
8
k TEST:WHEN THiS BU_ON iS PRESSED
OR WHEN THE_ _SiA CURREN_ LEAK,
THE UNiT WiLL NOT RUN,
[] RESET:AFER SOLVING THE PROBLEM,
PLE_.SEPRESSTHE BUTTON AND THE
UNiT WiLL STARTOPERaTiNG.
g
4
Note: PJease manually open the air outlet jJtem2) to desired position.
6

@
Accessories include ©
i. Plastic panel ° 3 pieces
From 20" (50°5cm)u,p to 46" (1 i 6.8cm)
2. Window Pond adapter ° i piece
3. Screws° 4 pieces
4_ Heat Exhaust hose connector - 2 pieces.
5. Heat Exhaust hose o 1 piece ,£
6. Cover ° 1 pieces .................
®
®
1. Push the round Window Panel .Adapter through the rear of the Plastic Panel.
Line up the hales and tighten the Adapter with 4 screws that are included in
the kit. (Tighten screws from the front.)
2. Adjust the Plastic Pand to the width or height of your window and tighten
the 2 screws that are attached to the pond.
3. install the Window Plastic Panel into the window, if necessary use duct tape
to better secure the panel
4_ Connect exhaust boise to the unit by inserting the hose connector that is
attached to the hose into the exhaust. (See illustration A)
5. Move the unit to the window, extend the hose and attach the other end of
the hose to the window. Align the tabs on the hose and window panel
adapters and fasten them togethen
Plug into waJJoutlet to get ready for operation_
6_
HOTE: Use @n Single @utter Circuit @nJyo
B
Hose Connector Q Exhaust Hos_ Hose,Connector
/.
/
7

@
¢@n_r@!Pan÷J
Temp and time setting Receiving sensor
Mod_ light
Power Control (Eme_ency)
Warning Light
Power ¢ont_J
Thepower control turns the unit on and off_
When you presspower controJ, the unit begins to
operate.
Warning LigB_
Condensed water may accurnuJate in the unit.
if the internal tank becomes fuji, the Warning
Light wiJl shine and the unit wiJJ not operate untiJ
the unit has been drained.
Ope_ing mode indica_r
indicator cdor of operating mode and LED :
When coding mode is seJected, the indicator
light wiJJbe bJueo
When dehumidi_ mode is seJected, indicator
Jight wiJJbe Orange.
When fan mode is sdected, indicator JightwiJJ
be green.
Tempo and Time Setting Jndica_t
During operation, the unit dispJays "present
room temperature."
®When setting temperature, the unit wilJ dispJay
set temperature.
When setting the time it dispJays "set time" and
indicator fJashes.
• 5 seconds after "set temperature" and "set
time", it goes. back to "present room tempera-
@
o
Temperature dispJay ranges from 61°F to 89°E
When environmental temperature is higher
than the temperature dispJay range, the dispJay
shows "HI".
When environmental temperature is Jower than
the. temperature dispJay range, the dispJay
shows "LO".
When the unit stops operating, indicator [ight
goes off.
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
7

O
Dehu_idi_ Mode
Air is dehumidified as it passes through air
conditioner, without being in fuji coding mode_
if room temperature is greater than 77°B fan
speed can be adjusted; otherwise fan speed is
fixed to "bw."
Fan Mode
Air is circulating throughout the room with no
coding.
N@te: Unit does not need to be vented in
FanMode.
P@wer ¢@nt_J
The power control turns the unit on and off:.
Mgde ¢@nt_J
There are 3 modds d Operations: "Cod" (When
unit is coding), "Dehumidify", and "Fan" (only Fan
running). A mode indicator light on the unit control
panel shows the following colors: Blue br'Cooi"
mode; Orange br"Dehumidify", and Green for
"Fan".
The unit wiJJsta4 in "Cod" made with a Blue
indicator lighL Once you press the "Mode" button
on the remote, it wiJJchange to "Dehumidi_" mode.
Pressthe,"Mode" button again to get "Fan" mode.
it goes back to the "Cad" mode once the "Mode"
buttan is pressed again°
Note: When you press "Up" and "Down" buttons
and there is no response, please press the "Mode"
button, until the unit indicator light is Blue ("Cod"),
you can, then adju4 the temperature accordingly.
oCooling Mode,
During the cading mode the air is coded and
hot air is exhausted to the outside air through
the air exhaust hose_ Adjust fan speed and
temperature to suit your desired comfort level
N@te: The air exchange hoses must vent
outside the room when using Cod Mode.
Fan Speed ¢ont_J
The Fan Speed Contrd has 3 settings:
High, Medium and Low.
Te_p _t ¢@nt_Js
Press "Up" or "Down" to set temperature.
setting range is from 61°F to 89°F_ The
Note::When using Dehumidify or Fan Mode,
temperature setting button is invalid.
Fahrenhei_i Celsius SeJec_or
Pressthe °C /°Fswitch button, to switch between
°Fand °C.
Note: initial setting is °F_
Ti_er S÷_ing ¢ont_J
®When you usethe timer setting button while the
unit is operating, you can preseta time for the
unit to turn off.
• When you use the timer setting button while the
unit is on standby, you can, presenta time for
the unit to turn on_
Jfyou press the '_ONiOFF" button, the preset
timer function wiJJbe cancelled.
®Timer se_ing range is 1~24 hours.
Ti_er Cancel Contain
o You,can cancel the timer setting at any time by
pressing the "Cancel _ button_
8
9

@ _@ @
Voltage and Frequency 1t5V /60Hz
input: Power 800 W
Cooling Capacity 7000 BTU
Moisture Removal (pints/day) 70
R-22/12.70z°
Timer 24 Hours
Operating Temperature Range 61°F- 100°F
Unit Dimensions (WxDxH) 17-15/16"x 13-_/8,'x 24-3/8"
Net Weight (approximate) 55.1 Ibso
Exhaust Hose 5 Feet
Always unplug your air conditioner before c_aning°
@
0Air filter needs b be dleaned at least once a week for your unit b operate at optimum
efficiency. Slide out the filter from the back by pulling on the tab. The filter may be washed
or vacuum@& Remove the excess water from the filter by gently shaking the fiJlter.This will
remove dust and particles trapped in the filter. After cleaning, reinstall the fiJten DO NOT
use your air conditioner without the air filter in place.
0To dean the cabinet, DO NOT use harsh, chemicais, abrasives, ammonia, chlorine, bleach,
concentrated detergents, sdvents or metal scouring pads. Some of these chemicals may
dissolve, damage and/or discolor your air conditioner.
o Always use a soft cloth dampened with water or a mild soap and water soJutioin to wipe the
front of the cabinet. Wipe dry with a sos cloth.
• To store your air conditioner when not in use for a long period of time, drain condensed
water using the drain pipe. Remove exhaust hose, dean the filters, cover with plastic bag
and store.
9
10