Haier Genesis CRDWE200AW User manual

On carpet, the floor must be solid with a maximum slope of 1 inch (2.54 cm).

4
White

Off Button: (1)
Note: Features may vary by
Not on when unit is turned on.
Off

Dark and light colored clothes should be separately dried. Fabrics prone to
creating lint and those prone to accumulating lint should be separately
dried. Clothes prone to creating lint should be turned inside out before
putting into the dryer.
Make sure buttons and ornaments on the clothes are high temperature
resistant and won't damage drum surface. Before loading, the clothes
should have their zippers zipped up, buttons and hooks done up and belts
tied so as to avoid entanglement or other obstacles.
If possible, turn out the clothes pockets for uniform drying.
Check if clothes remain soiled. If yes, wash it away again, otherwise the soils
after drying may not be removed permanently.
Small articles should be collected in a mesh bag before loading and
drying to avoid entanglement and ensure that they can be found easily.
Make sure power socket is reliably grounded. The grounding terminal must
not be connected to gas or tap water pipelines.
Make sure exhaust duct has been connected with extension pipe.
Make sure lint filter is clean and then assemble it properly. If lint filter is not in
place, tumbling items could enter the exhaust system and cause damage
to the dryer.
Notes: This applies to Auto Dry cycle and Timed Dry cycle. For Rack Dry
cycle, remove the lint filter and assemble the drying rack with its rear end
slightly downward inclined. The assembled status is as shown in the following
figure:

The appropriate load shall be 1/3 ~ 1/2 of the drum volume. Avoid overloading,
for a certain space is needed to allow clothes free rotation for uniform and
wrinkle-proof drying.
When drying large articles, only 2-3 large pieces should be loaded at a time
and supplemented with medium and small articles.
For elaborate clothes or a small load, two towels without lint may be added to
get better drying and wrinkle-proof effects.
Do not excessively dry clothes to avoid wrinkles, shrinkage, roughness,
electrostatic charges, and lint.
This program is designed especially for articles like sneakers. During drying
please make sure the clothes reliably stay on the rack with no risk of entangling
the agitation blade while drum is rotating.
Note: If drying rack is not in place, rolling inner tub could collide with drying
rack and causes damage to the dryer and drying rack.
the unit
automatically cuts Off power and returns to off status;
The unit returns to Off status immediately upon end of a cycle; Pressing
Off button will stop all operations and power the unit off during any status.