Haier HDY-D60 User manual

15 Do not dry unwashed items in the tumble dryer.
16 Fabric softeners, or similar products, should be used as specified by the fabric
softener instructions.
17 To prevent fire, do not use heat to dry items containing plastic, foam rubber or
similarly textured rubber-like materials, or items containing feathers or down. Items
such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed
articles and clothes or pillows fitted with foam rubber pads should not be dried in the
tumble dryer.
18 This dryer must be properly installed in accordance with the installation instructions
before it is used.
19 Do not install or store this dryer where it will be exposed to water and /or the weather.
Keep surrounding areas free from the accumulation of lint, dust and dirt.
20 To prevent shock hazard and assure stability during operation, the dryer must be
installed and electrically grounded by a qualified service person in accordance with
local codes.
21 Do not sit on top of the dryer.
22 If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
23 Always disconnect dryer from electrical supply before attempting any service.
Disconnect power cord by grasping the plug, not the cord.
24 Do not repair or replace any part of the dryer or attempt any servicing unless
specifically recommended in the user-maintenance instructions.
25 Before the dryer is removed from service or discarded, remove the dryer door to
prevent accidental entrapment.
2
14
14
15
INSTALLATION INSTRUCTIONS
FREE STANDING
INVERTED WALL MOUNTING
STACKING INSTALLATION 11
CHANGE THE VENTING MODE 12
INSTALL THE FLEXIBLE HOSE 13
Caution, risk of fire - this is a safety symbol. Failure to follow the warnings
outlined in these user instructions can cause a fire hazard.
26 Remove all objects from pockets such as lighters and matches

1. Power up
Insert the power plug into an appropriate power outlet that is properly installed and
grounded. Operating power supply: 220-240V~50Hz.
2. Laundry loading
Open the door and load the laundry into the drum of the dryer. For a more energy
efficient and better drying result, make sure the load has been spun dry. Try to
loosen the load when placing in the dryer.
Note: Check labels on clothing before placing them in the dryer. Some articles are not
suitable for machine dry. High temperature may damage the fabric.
3.Setting drying time
Turn the program knob to set your desired drying program.
4. Program operation
After a program is set, gently touch the “START/PAUSE” button to start the program.
5. Program completion
After the program is complete, the dryer will stop tumbling and the indicator light
will be blinking. Open the door and remove the laundry.
6. Turning off the dryer
Turn the program knob to the “OFF” position and turn the power off at the wall.
Note: Clean the filter after each load.
5
May be tumble dry .
Do not tumble dry .
Normal dry .
Air dry, only .
If the laundry is not removed, the dryer will automatically commence an "anti-crease"
protection cycle to keep your laundry from settling in one position and creasing. This
cycle will last an hour unless stopped. The light will blink and the dryer will run with
cool air at set intervals. To stop the anti-crease cycle press the start pause button,
empty the dryer and turn off as shown below.

WARNING! Unplug the power cord prior to any cleaning
Cleaning the surface
Wipe off any dust or dirt.
Note: Do not use excessive water,. a damp cloth is fine.
Do not use solvent.
Do not use spray cleaners when cleaning the interior.
Do not use harsh or abrasive cleaners.
Cleaning the filter screen
To ensure good ventilation during drying, the filter screen must be cleaned before
or after each use.
1. Remove the filter
Gently pull out the filter screen towards yourself.
2.Cleaning the filter
Remove the lint with a soft brush or vacuum
cleaner. Be careful not to damage the filters.
Remove any remaining lint from the lint screen
on the door.
3. Re-installing the filter
After cleaning filters, put the screen back in place.
Note: Never operate your dryer without the lint filter.
7

Remove the transport packaging (fig.1)
Remove the tape on the door (fig.2), the wall mounting kit and the inverted panel
film attached to the inside of the drum (fig.3) before starting the dryer.
Packing accessories
Check list of the accessories and materials provided with the machine:
To ensure the dryer operates normally, attention must be paid to the
following:
1. The rear of the dryer must not have any restriction to the intake of fresh
air.
fig.1 fig.2
Dimensions
a=830 mm
b=600 mm
c=560 mm
Weight=30 kg
INSTALLATION INSTRUCTIONS
2. Check the dryer for any damage. If any damage is found do not operate
and contact your supplier or Authorised Service Centre.
3.The dryer must be kept away from flammable substances.
4.The surrounding environment must be dry and ventilated.
5. For best resultsthe ambient temperature should be between 10
and 35 .
8
fig.3
Name Quantity
User manual 1
Wall mounting kit 1
Inverted panel film 1
Flexible hose 1
Flexible hose clip 1
Hose connector 1
Unpacking your dryer
Stacking kit 1