
MANOK plus
Order hotline +49 7144.907-333
4.3.1 Jaw module .................................................................................27
4.3.2 Magnet module............................................................................27
4.3.3 MANDO Adapt.............................................................................28
4.3.4 Morse taper adaptation................................................................28
4.3.5 Face driver adaptation.................................................................28
4.3.6 vario part end-stop system..........................................................28
4.3.7 vario quick end-stop system........................................................29
4.3.8 Torque wrench kit........................................................................29
4.4 Special aids...............................................................................................29
4.4.1 Key..............................................................................................29
4.4.2 Manual changing fixture ..............................................................29
4.4.3 Pneumatic changing fixture .........................................................29
5Use and limits of use.........................................................................................30
5.1 Use............................................................................................................30
5.2 Limits of use..............................................................................................30
5.2.1 Nomenclature..............................................................................31
5.2.2 First limit [workpiece length] ........................................................33
5.2.3 Second limit [workpiece mass] ....................................................33
5.2.4 Third limit [clamping length].........................................................34
5.2.5 Fourth limit [forces]......................................................................34
5.2.6 Sample calculation ......................................................................46
6Transport, packaging, storage...........................................................................50
6.1 Safety, transport, packaging, storage .......................................................50
6.2 Symbols on the packaging........................................................................51
6.3 Transport inspection..................................................................................51
6.4 Unpacking and internal transportation.......................................................52
6.5 Packaging.................................................................................................52
6.6 Storage .....................................................................................................53
6.7 Preservation..............................................................................................53
6.8 Return to storage ......................................................................................53
7Installation.........................................................................................................54
7.1 Installation safety ......................................................................................54
7.2 Preliminary remarks..................................................................................55
7.3 Screw tightening torques...........................................................................56
7.4 Preparation of the machine for installation................................................57
7.5 Installation of the product..........................................................................58
7.5.1 Compatibility check......................................................................58
7.5.2 Preparation of the product...........................................................58
7.5.3 Installation of the product on the machine...................................59
7.6 Installation of the clamping element..........................................................61
7.7 Installation of the changing parts ..............................................................63
7.7.1 Installation of the variant, screwed directly..................................64
7.7.2 Installation of the variant x-times with axial screw connection.....64