HAKO Scrubmaster B12 User manual

Hako Scrubmaster B12
1. Disconnect mains plug of the charger from outlet and fasten to holder 1.
2. Fill the clear water tank 2 from opening 3.( tank volume 16 l )
3. Switch the machine on y the switch 4.
4. Adjust the height of the handle with lever 5.
5. Use pedal 7 to lower squeegee 6.
6. Start the suction motor 8 and water 9.
7. Pull the starting lever to handle 10. Brushmotor starts.
8. Move on. Use switch 11 under the machine to adjust the water ( if
necessary )
NOTE! Make sure that pad / rush is installed!!!
OPERATION:
Qualified persons only are authorised to operate the machine!
The machine is not designed for coarse material! Floor area sweeping efore!
Use only cleaning agents suita le for automatic machines ( low-foaming )!
Please pay attention to the informations in the instruction manua!
1
3
2
5
4
6 8
7
9
11
10

Hako Scrubmaster B12
Daily maintenance:
Empty the clear water tank 1from the
valve 2.
Empty soiled water tank 3 y the soiled
water drain hose 4. Clean soiled water tank.
Check and clean tank lid and lid sealing 5.
Check and if necessary clean the float 6.
Remove suction hose 7 and clean it.
Remove squeegee 8and clean it.
Remove rush / pad holder 9and clean
rush / pad. Check rush / pad for wearing.
Charge attery ( take plug from holder 10
and connect with outlet ).
Turn off the machine efore maintenance!
Please pay attention to the informations in the instruction
manual, you can find manual y reading QR-code.
8
6
10
5
4
3
2
11
7
AINTENANCE AND CARE :
Weekly maintenance:
Check and clean rush head 9
Check and clean clear water filter 11
Clean the machine from outside
Check squeegee sealing strips and turn or
replace them if necessary
Cleaning result is bad:
osuction hose 7or squeegee 8is locked.
oLocking cap of the soiled water drain hose
4is open
oTank lid sealing 5 of the soiled water tank
is defect.
9
1