HK-61902
USER GUIDE
Action LED
Turn on the device Push the button Red and Green LED´s light up simultaneously
Reset the device after a test Push the button Red LED is turned off, Green LED starts flashing
Turn off the device Push the button Green LED is turned off
LED indications
Emulator is operational (battery ok) Green LED is flashing
Output has been activated Green LED is turned off, Red LED is flashing
Low battery voltage on Emulator Red and Green LED will give alternating flashes and the
device will be switched off again.
FIRST TIME OF USE
• Open the Emulator enclosure by gently twisting a screwdriver in the slot at the side of the enclosure.
• Insert a CR2032 battery in the battery holder.
• Attach two connection wires to the terminals on the Emulator. (Do not use to much torque on the terminal screws)
NORMAL USE
• Open the enclosure and push the pushbutton on the circuit board to switch on the Emulator.
The red and the green LED on the circuit board shall light up simultaneously when the pushbutton is pushed. If the battery is ok the green
LED will start flashing green and the device is ready to be used.
• Attach two connection wires to the terminals on the Emulator. (Do not use to much torque on the terminal screws)
• To test the system, connect the wires to the Electronic Remote Release System ERU output. (The polarity is not important)
TEST THE ELECTRONIC REMOTE RELEASE SYSTEM
• Activate the output on the Electronic Remote Release System and check that the flashing green LED is turned off and that the red LED
has started to flash.
• If the green LED is turned off and the red LED are turned on (flashing) the ERU output signal from the Electronic Remote Release System
has been ok.
NB! The ERU Emulator does not break the circuit when it is activated and it will be detected as an installed ERU by the ERRS system
even if it has turned from green to red.
REPEAT THE TEST
Push the pushbutton on the circuit to reset the Emulator. When the green LED is flashing, the device is ready to be used again.
TO TURN OFF THE EMULATOR
• If a test has been performed, the Emulator has to be reset to a flashing green status.
• Then again push the pushbutton and the device will be turned off and the LED´s will stop flashing.
The device will turn itself off automatically 30 minutes from the last push on the pushbutton.
The DIP switches are not used in this application and shall be in off position.
