Hannlomax HX-200 User manual

ALARM CLOCK RADIO WITH USB CHARGING
Model : HX-200
Note: Please read and follow these instructions before using your unit.
WARNING
TO PREVENT ELECTRIC S OCK; DO NOT USE T IS PLUG WIT AN EXTENSION CORD RECEPTACLE OR
OT ER OUTLET UNLESS T E BLADES CAN BE FULLY INSERTED TO PREVENT BLADES EXPLOSURE.
TO PREVENT FIRE OR S OCK AZARD; DO NOT EXPOSE T IS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lighting flash with
arrowhead symbol, with an
equilateral triangle is intended to
alert the user to the presence of
un-insulated dangerous voltage
within the products enclosure
that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
CAUTION: TO REDUCE T E
RISK OF ELECTRIC S OCK, DO
NOT REMOVE COVER (OR
BACK). NO USER
SERVICEABLE PARTS INSIDE
REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instruction in the literature
accompanying the appliance.
1. Keep these instructions.
2. eed all warnings.
3. Follow all instructions.
4. Do not use this apparatus near water.
5. Clean only with dry cloth.
6. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
8. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
9. Only use attachments/accessories specified by the manufacturer.
10. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
2) Unplug the apparatus during lightning storms or when unused for long periods of time.
3) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
FCC NOTICE
This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
-1-
LOCATION OF CONTROL
1 /SOURCE / AL.OFF Button 10 ALARM1 RADIO Indicator
2 TIME / MEM / M+ Button 11 ALARM2 BUZZER Indicator
3 AL1 / VOL− Button 12 ALARM2 RADIO Indicator
4 AL2 / VOL+ Button 13 LED Display
5 OUR / SKIP− Button 14 Speaker
6 MIN / SKIP+ Button 15 AC Adapter
7 SNOOZE/SLEEP/DIMMER Button 16 USB Port for Charging (1A)
8 PM Indicator 17 Battery Compartment
9 ALARM1 BUZZER Indicator
CONNECTING THE UNIT TO POWER
Plug AC power adapter to the AC wall outlet. Before switching on the unit, make
sure that the voltage of your electricity supply is the same as that indicated on the
rating plate.
BATTER BACKUP
Insert two pieces UM-4 batteries into the battery compartment. Be sure to observe
the proper polarity (the "+" and "-" signs) as indicated inside the battery
compartment.
In case of power failure or interrupted AC power, the current time and alarm time
settings, the stored radio stations are preserved in the memory of the unit by
means of battery back-up function.
-2-

SETTING THE CLOCK
1. With the unit in CLOCK mode (RADIO off), press and hold the TIME/MEM/M+
button for about 1 second, the time will begin to flash on the LED display.
2. Press the HOUR button to adjust the hour.
3. Press the MIN button to adjust the minute.
4. When the correct time is selected, press the TIME/MEM/M+ button again to
confirm.
SETTING THE ALARMS
1. With the unit in CLOCK mode (RADIO off), press and hold the AL1 or AL2
button. The ALARM time will begin to flash on the LED display.
2. Press the HOUR button to adjust the alarm hour.
3. Press the MIN button to adjust the alarm minute.
4. When the correct time is selected, press the AL1 or AL2 button to confirm.
5. Press the AL1 or AL2 button to select the ALARM sound mode – [B] buzzer or
[R] currently set radio station. The corresponding LED indicator will light up.
SNOOZE FUNCTION
1. Whenever the alarm (buzzer or radio) activates, it can be temporarily suspended
for a short period of 9 minutes by pressing the SNOOZE/SLEEP/DIMMER
button once.
2. The buzzer or radio will then automatically activate again after the 9 minutes
SNOOZE period has ended.
3. This procedure can be repeated for up to approximately one hour.
TURN OFF THE ALARM
When the Alarm activate, press the /AL OFF button to turn off the Alarm.
LISTENING TO THE RADIO
1. Press the /AL OFF button to select the FM radio mode
2. Press the SKIP+ or SKIP− buttons step by step to tune to the desired radio
stations.
3. Press and hold the SKIP+ or SKIP− buttons for approx. 1 second, it will start to
search the next radio station in the direction of the search. The search operation
simply finds stations with strong signals. Stations with weak reception can only
be tuned in manually.
4. Press the VOL+ or VOL− button to adjust the sound to the desired listening
level.
5. For Better reception, fully extend and adjust the position and direction of the AC
adapter cord that acts as an FM antenna.
-3-
SAVING A RADIO STATION TO THE MEMOR
1. Tune the radio to the desired station.
2. Press the TIME/MEM/M+ button for approx. 1 second, the LED display will show
PXX where ‘XX’ is the next radio station number in the memory
3. Press the SKIP+ or SKIP− button to select the desired station number then
press the TIME/MEM/M+ button to store the station in the memory.
4. Up to 10 FM radio stations can be stored in the memory.
TO LISTEN TO A SAVED RADIO STATION
Press the TIME/MEM/M+ button to select the stored radio station.
SLEEP TO MUSIC FUNCTION
1. This function allows you to listen to the radio while you fall asleep.
2. Press the SNOOZE/SLEEP/DIMMER button, the display will show the default
sleep time of 90 minutes showing in the display.
3. Press the SNOOZE/SLEEP/DIMMER button again to adjust the desired sleep
time.
4. Now you can enjoy listening to the radio for the pre-set period of sleep time.
5. After this pre-set time has elapsed, the unit will switch off automatically.
DISPLA BRIGHTNESS
Press the SNOOZE/SLEEP/DIMMER button to change the display brightness.
TURN OFF THE RADIO
Press the /AL OFF button to turn off the radio.
CHARGE OUR DEVICES (1A CHARGING)
Connect the standard size end of a USB cable (not included) to the USB port on
the unit and connect the other end to the charging port your device.
Remarks: Some devices may not support USB charging or may require a higher
power rating than this product provides. Observe the charging status on your
device. Ensure your device is working properly before attempting to charge.
Charging function may not be supported for all phones or electronic devices
SPECIFICATIONS
Frequency Range: FM: 87.5 - 108 M z
Power Supply: AC 100-240V ~ 50/60 z
Rated Output DC5V 1.5A
Back-Up Battery: 2 pcs. UM4 “AAA” size (Battery not included)
USB Charging: 1A
Specifications are subject to change without prior notice.
-4-