Hannlomax HX-134CR User manual

ALARM CLOCK RADIO
Model : HX-134CR
Note: Please read and follow these instructions before using your unit.
WARNING
TO PREVENT ELECTRIC S OCK; DO NOT USE T IS PLUG WIT AN EXTENSION CORD RECEPTACLE OR
OT ER OUTLET UNLESS T E BLADES CAN BE FULLY INSERTED TO PREVENT BLADES EXPLOSURE.
TO PREVENT FIRE OR S OCK AZARD; DO NOT EXPOSE T IS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lighting flash with
arrowhead symbol, with an
equilateral triangle is intended to
alert the user to the presence of
un-insulated dangerous voltage
within the products enclosure
that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
CAUTION: TO REDUCE T E
RISK OF ELECTRIC S OCK, DO
NOT REMOVE COVER (OR
BACK). NO USER
SERVICEABLE PARTS INSIDE
REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instruction in the literature
accompanying the appliance.
1. Keep these instructions.
2. eed all warnings.
3. Follow all instructions.
4. Do not use this apparatus near water.
5. Clean only with dry cloth.
6. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
8. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
9. Only use attachments/accessories specified by the manufacturer.
10. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
2) Unplug the apparatus during lightning storms or when unused for long periods of time.
3) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
FCC NOTICE
This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
-1-
LOCATION OF CONTROL
1 SOURCE
 Use this button to select AM or FM band.
 Use this button to turn the ALARM off after Alarm activates.
2 CLK / MEM
 Use this button to set the clock
 Use this button to store radio stations in the memory.
 Use this button to select the stored radio stations in the memory.
3 VOL- / AL2
 Use this button to decrease the volume.
 Use this button to set the alarm time in ALARM 2.
4 VOL+/ AL1
 Use this button to increase the volume.
 Use this button to set the alarm time in ALARM 1
5 TUN < / MIN
 Use this button to search the radio station in backward direction.
 Use this button to adjust the minute in CLOCK or ALARM time.
6 TUN > / HR
 Use this button to search the radio station in forward direction.
 Use this button to adjust the hour in CLOCK or ALARM time.
7 SNOOZE
 Use this button to temporarily suspend the ALARM for a short period.
 Use this button to set the sleep time.
8. PM INDICATOR (This indicator shows that the time display is PM)
9. ALARM1-BUZZER INDICATOR(This indicator shows that the unit is in ALARM-1 buzzer mode.)
10. ALARM1-RADIO INDICATOR(This indicator shows that the unit is in ALARM-1 radio mode.)
11. ALARM2-BUZZER INDICATOR(This indicator shows that the unit is in ALARM-2 buzzer mode.)
12. ALARM2-RADIO INDICATOR (This indicator shows that the unit is in ALARM-2 radio mode.)
13. LED DISPLAY(Display for the Clock and the Radio frequency.)
14. SPEAKER(Sound output.)
15. FM WIRE ANTENNA(Extent this wire antenna to obtain better FM broadcasting.)
16. DC JACK(Connect the unit to the AC/DC adaptor.)
17. BATTERY COMPARTMENT (Compartment for the back-up battery.)
-2-

CONNECTING THE UNIT TO POWER
Plug one end of the AC adaptor into the DC power Input, and then plug the other
end into AC wall outlet. Before switching on the unit, make sure that the voltage of
your electricity supply is the same as that indicated on the rating plate.
BATTERY BACKUP
Insert two pieces UM-3 batteries into the battery compartment. Be sure to observe
the proper polarity (the "+" and "-" signs) as indicated inside the battery
compartment.
In case of power failure or interrupted AC power, the current time and alarm time
settings, the stored radio stations are preserved in the memory of the unit by
means of battery back-up function.
SETTING THE CLOCK
1. With the unit in CLOCK mode, press and hold the CLK/MEM button for about 1
second, the time will begin to flash on the LED display.
2. Press the TUN>/ R button to adjust the hour.
3. Press the TUN</MIN button to adjust the minute.
4. When the correct time is selected, press the CLK/MEM button again to confirm.
SETTING THE ALARMS
1. With the unit in CLOCK mode, press the VOL+/AL1 or VOL-/AL2 button. The
ALARM time will begin to flash on the LED display.
2. Press the TUN>/ R button to adjust the alarm hour.
3. Press the TUN</MIN button to adjust the alarm minute.
4. When the correct time is selected, press the VOL+/AL1 or VOL-/AL2 button to
confirm.
5. Press the VOL+/AL1 or VOL-/AL2 to select the ALARM sound mode - buzzer or
currently set radio station. The alarm buzzer or radio indicator will light up.
SNOOZE FUNCTION
1. Whenever the alarm (radio or buzzer) activates, it can be temporarily suspended
for a short period of 9 minutes by pressing the SNOOZE button once.
2. The buzzer or radio will then automatically activate again after the 9 minutes
SNOOZE period has ended.
3. This procedure can be repeated for up to approximately one hour.
TURN OFF THE ALARM
When the Alarm activate, press the SOURCE button to turn off the Alarm.
-3-
LISTENING TO THE AM/FM RADIO
1. Press the SOURCE button to select AM or FM band
2. Press the TUN>/ R or TUN</MIN buttons step by step to tune to the desired
radio stations.
3. Press and hold the TUN>/ R or TUN</MIN buttons for approx. 1 second, it will
start to search the next radio station in the direction of the search. The search
operation simply finds stations with strong signals. Stations with weak reception
can only be tuned in manually.
ANTENNA
For best reception, fully extend the FM wire antenna to receive FM stations. For
AM reception, the unit has a built-in antenna, turn the whole unit for best reception.
SAVING A RADIO STATION TO THE MEMORY
1. Tune the radio to the desired station.
2. Press and hold the CLK/MEM button for approx.. 1 second, it will store this radio
station in the memory.
3. Up to 10 AM and 10 FM radio stations can be stored in the memory.
TO LISTEN TO A SAVED RADIO STATION
1. Press the SOURCE button to select AM or FM band.
2. Press the CLK/MEM button to select the stored radio station.
SLEEP TO MUSIC FUNCTION
1. This function allows you to listen to the radio while you fall asleep.
2. Press the SNOOZE button, the display will show the default sleep time of 90
minutes
3. Press the SNOOZE button again to adjust the desired sleep time.
4. The options are 90-80-70-60-50-40-30-20-10-min. or OFF
5. Now you can enjoy listening to the radio for the pre-set period of sleep time.
6. After this pre-set time has elapsed, the unit will switch off automatically.
SPECIFICATIONS
Frequency Range: AM 520 - 1710 K z
FM 88 – 108 M z
Power Supply: AC 120V ~ 60 z
AC/DC Adaptor DC6V ~ 100mA
Back-Up Battery: 2 pc. UM3 ‘AA’ size
Specifications are subject to change without prior notice.
-4-