Hanover Brigantine Rectangular Cast-Top Dining Table User manual

Brigantine Rectangular Cast-Top Dining Table
Owner’s Manual
Page 1 of 4
If you have any problems with this product, DO NOT RETURN IT TO THE
STORE. CALL OUR CUSTOMER SERVICE HOT-LINE AT
8AM –5PM (EST), Monday –Thursday
8AM –4PM (EST), Friday
[phone]

W A R R A N T Y
Care and Maintenance
Be careful to never allow water to build up in frames as this will cause corrosion and freeze damage in cold climates. Wash
all frames with a solution of mild soap and water. Rinse with clean water and dry with a soft absorbent cloth towel. Frames
can be treated with a liquid wax for maximum protection against UV rays and/or salty damp air. If your set includes cushions,
slings, and/or an umbrella they may be cleaned by hand with a solution of soap and water with a clean water rinse. (Never
machine wash cushions, slings or umbrella covers as this will result in shrinkage or damage).
After cleaning cushions tip on end and allow to drip dry. (Never use a commercial or home dryer to tumble dry fabric goods).
Do not use bleach or solvents to clean any product! This will void the warranty.
Lack of original receipt will void warranty!
In order to activate your warranty please register at www.bjifurniture.com. There you can review our full warranty
details and other helpful information. Or, you may call us at , 8am –5pm (EST), Monday –Thursday,
8am –4pm (EST), Friday.
NOTE: Do not allow children to play with plastic wraps or small parts to prevent potential choking hazard.
Page 2 of 4
[phone]

PARTS LIST
PART# DESCRIPTION PICTURE Q’TY
A Table Top 1
B Table Leg 4
C Support Tube 4
D
E
Bolt M6x20
F
Bolt M6x35
G
H
Washer
Bolt Cover
Open Wrench
4
12
16
16
1
Page 3 of 4

Page 4 of 4
Figure 1
Figure 3
Step 2. Assemble the table legs (B) to the table top (A) with bolts (D&E) and washer (F) as shown in figure 1.
Figure 2
A
EDB
FF
G
G
E
C
F
G
Step 4. Check the alignment and adjust if necessary. Once the alignment is correct, tighten all bolts with
open wrench ( ) . Cover all bolts with bolt caps(G).
Step 5. Verify all bolts are securely tightened before use and turn your table right side up. Your table is
now ready to use. (Figure 3).
H
Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Carefully place the table top (A) upside down on a non-abrasive surface.
Step 3. Loosely attach the support bar (C) to the table leg (B) and table top (A) with bolts (E) and washer (F)
as shown in figure 2.