Hanover HVLND200 User manual

A
A
A
A
B
B
4MM HEX KEY, ALLEN, T-HANDLE
(INCLUDED)
A - .273 X 2.50 SOCKET WAFER A
4
B - .273 X 3 SOCKET WAFER A
2
Qty. Description
MODEL: HVLND200
__(1) Chair frame
__(1) Back assembly
__(1) Hardware pack
Step 1
Place back assembly in chair frame by
slipping bottom in first, then rotate back
into position as shown
Step 3
Attach arms to back assembly
using (2) .27x3" Screws
TOOLS NEEDED
Step 2
Attach back assembly to seat using
(2) .27x2-1/2" Screws
Atach back assembly to the
top of the back leg using
(2) .27x2-1/2" Screws
HARDWARE IS COATED STAINLESS STEEL UNLESS OTHERWISE SPECIFIED
4MM HEX KEY, ALLEN, SHORT ARM
(INCLUDED)
6/25/2015
ASSEMBLY INSTRUCTIONS

FINE THREAD
4
C - 1/4-20 X 3-1/4 WAFER SHCS
B
B
Removable table plug
included in table
A
C
4
B - .273 X 3 SOCKET WAFER A
- 4mm HEX KEY, ALLEN, T-HANDLE
(INCLUDED)
A - 14 X 2.50 HEX WASHER T-A ALCHM
8
Qty. Description
MODELS: HVRT248, HVRBT248
Step 2
Lay the table top on a flat surface.
Attach the leg assemblies to the table top using
(8) 2 1/2" hex screws.
Step 3
Attach braces to leg assemblies using
(4) 3" screws.
Set table upright and tighten all bolts
TOOLS NEEDED
Step 1
Attach feet to legs using
(4) 3 1/4" Chair bolts.
__(1) Table top
__(4) Leg
__(2) Foot
__(2) Brace
__(1) Hardware pack
HARDWARE IS COATED STAINLESS STEEL UNLESS OTHERWISE SPECIFIED
A
- 3/8" Wrench
6/25/2015
ASSEMBLY INSTRUCTIONS