Hanover Tiffany Platform Bed User manual

Platform Bed
Contains One (1) Bed and Hardware
IMPORTANT NOTE:
Carefully remove all the parts from the box
surface and verify you have all of the following parts and hardware.
PARTS LIST
HARDWARE LIST
(Continued on back)
J. 40mm Bolt
(2 pcs)
K. 60mm Bolt
(2 pcs)
L. Hex Key
(1 pc)
I. 25mm Bolt
(8 pcs)
H. 20mm Bolt
(4 pcs)
A
A. Headboard
(1 pc)
B. Footboard
(1 pc)
E. Crossbar
(2 pcs)
D. Center Support
(1 pc)
C. Siderail
(2 pcs)
F. Support Leg
(4 pcs)
G. Wood Slat System
(1 pc)
SIZE: QN, DB

STEP 1 STEP 2
STEP 4
ASSEMBLY INSTRUCTIONS
STEP 3
A
Attach the Siderails (Part C) to the Headboard (Part A) and
Footboard (Part B) by inserting the bolts on the Siderails into
the slots on the Headboard and Footboard.
Attach the Crossbars (Part E) to the Siderails using two
20mm bolts (Part H) for each Crossbar.
Install the Center Support (Part D) by inserting one 60mm
bolt (Part K) through the Crossbar and Center Support at both
ends of the bed. Then screw the end of each 60mm bolt into
a Support Leg (Part F). Attach the remaining two Support
Legs to the Center Support using the 40mm bolts (Part J).
Roll out the Wood Slat System (Part G) and secure it in place
using the eight 25mm bolts (Part I).
I
I