Hanover HSD0411-NAT User manual

Assembly & Care Guide
For Motorized Lift Desk
MODEL: HS D0411
t

allen key

Position the hand switch (3) as shown in the picture to align the
three predrilled holes on the tabletop underside, then affix with
the screws (A) and tighten with 5*5 Allen key (D)

Up button, adjust the desk upwards
Down button, adjust the desk downwards
Position 1, user’s first stored height position
Position 2, user’s second stored height position
Position 3, user’s third stored height position
Position 4, user’s fourth stored height position
Height Adjustable Funcon: 1. Press the “ ▲” buon, the desk rises, press and hold to connue
will show “bot” when descending to the lowest point
Height Memory Funcon:
2. Press the “▼ ” buon, the desk descends, press and hold to connue to descend, the screen
to rise, the screen will show “top” when rising to the highest point
1. When the desktop is staonary, press and hold the buon “1” for
3 seconds, the buzzer will generate a sound prompt and the display shows “S-1”, the save
is successful, and then adjust the desktop to any height, click the buon “1” to adjust the desk
to the original memory height.
2. Buon “2”, ”3”, ”4”all have the same memory height funcon as Buon “1”, repeat the above
steps.

Reset Operaon: 1. When the height of the device is incorrect or an error code appears, the
device needs to be reset and corrected. Press and hold the buon”3” and buon”4”
simultaneously for 3 seconds to enter this funcon.
2. Aer entering the reset funcon, the display shows “RST”, press and hold the “▼” buon to
reset the device. When the desktop descends to the lowest height, it will bounce upward
and run unl it is displayed “bot”, that is, the reset is completed.
Adjust the An-Collision Sensivity: 1. Press and hold the ” ▲”buon and ” ▼”buon
simultaneously for 3 seconds to switch the sensivity. Switch 1 gear for every operaon, there
are 4 gear range, A-0, A-1, A-2,A-3.
2. When the display shows “A-0”, the desk turns off the an-collision funcon; “A-3” for high
sensivity; “A-2” for middle sensivity; “A-1” for low sensivity. (Factory default A-0)
3. When the desk rises or descends, it will rebound immediately when it encounters an
obstacle to protect.
Troubleshoong:
1. Reset: When the LED shows" " or " ", press and hold “▼”buon to reset the desk,
when the desktop descends to the lowest height, it will bounce upward and run unl the LED
shows “bot”, that is, the reset is completed.
2. When it does't work and the LED shows "E01" or "E02", please retry 18 mins later.
3. If the “▼” buon does't work, and the LED shows other code, please check the cable connecon
and then cut off thepower for at least 10 seconds. Reconnect to the power and press “▼” buon to
start the reset process when it shows the " " or " " .
4. If all these above process are inefficient, plz contact our customer service.