Hans Grohe Metris S 31060000 User manual

1
English
assembly instructions

2
Assembly connecting hoses

3

4
Installation kit

5
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing
washer in position on the basin / bidet.
3. Slip the slide washer, washer and collar nut
over the threaded base and tighten the
collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves; cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with waterdimmer®
(flow limiter).
Rate of flow with waterdimmer:
7 l/min 0,3 MPa
Rate of flow without waterdimmer:
14 l/min 0,3 MPa
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5
MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bars = 147 PSI)
Hot water temperature: max.80° X
Recommended hot water temp.: 65° C
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (6a) located behind the
aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 7.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 4
1 handle 31093000
1.1 screw cover 96338000
2 nut 97406000
3 nut 97209000
4 cartridge cpl. 92730000
5 seal 95008000
6 aerator cpl. 13912000
7 fixing set 13961000
8 connection hose 96321000
9 pull rod 96657000
10 ball joint 97362000
11 aerator cpl. 97360000
12 connection hose 97206000
13 supply pipe 96638000
14 connection hose (31060003) 97443000
Special accessories
X special tool set 58085000
(order as an extra)
English

6
Test certificate
DVGW P-IX SVGW ACS NF WRAS KIWA
31060000 P-IX
9950/IA X X
31060003
31061000 P-IX
9950/IA X
31066000
31068000 P-IX
9950/IA
31261000 P-IX
9950/IA
31262000

7
Hot water limiter: hot water temperature 60 C, cold water temperature 10 C, flow rate 0,3 MPa.

8
Hansgrohe · Postfach 1145 · D-77761 Schiltach · Telefon [phone] · Telefax +49 (0) 7836/511440
E-Mail: [e-mail] · Internet: www.hansgrohe.com
01/2008 9.05364.04 English
The QuickClean cleaning function only needs a
small manual rub over to remove the lime scale from
the spray channels.
Cleaning