Harbor Freight Tools 66151 Assembly instructions

Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Copyright©2008 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product
described herein. Tools required for assembly and service may not be included.
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-800-444-3353 as soon as possible.
Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual
near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
Owner’s Manual & Safety Instructions
Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
ITEM 66151
REV 12b
REMOTE CONTROL
STUNT CAR

Page 2 For technical questions, please call 1-800-444-3353. Item 66151
Specifications
Batteries Required 4x “AA” Batteries (for Car)
1x 9V Battery (for Remote)
Frequency 49 MHz
FCC ID: VI8SB073111734249
Important Safety Information
1. Changes or modifications not
expressly approved by the party
responsible for compliance
could void the user’s authority
to operate the equipment.
2. When using, basic safety precautions
should always be followed to
reduce the risk of personal injury
and/or damage to the product.
3. Do not allow children younger
than age 9 to use this Stunt Car.
Children should not operate
without adult supervision.
4. Sharp antenna on Remote
can cause injury.
5. Keep spectators and pets away.
Spectators should only watch
from a safe distance.
6. Position batteries in proper polarity
and do not install batteries of
different types, charge levels,
or capacities together.
7. Do not open the Stunt Car’s
housing or to modify its design.
Doing so may cause damage
and/or make it dangerous.
8. Do not use if parts are loose
or damaged. If the toy has been
damaged, immediately stop use.
9. Only use outside or in large,
enclosed area. Do not drive near open
flames, pets or delicate furniture.
10. If you start losing control, gently
reduce speed and stop the Stunt Car.
11. The warnings, cautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
that cannot be built into this product
but must be supplied by the operator.
12. Maintain product labels and
nameplates. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
Assembly
1. Carefully slide the foam box containing
the Stunt Car from the cardboard box.
2. Remove the Remote and the antenna.
3. Thread the Antenna into the
top of the Remote.
4. Remove the Stunt Car from the foam
package. If any part seems to not
come out easily, stop and remedy
the obstruction before proceeding.

Page 3For technical questions, please call 1-800-444-3353.Item 66151
Installing Batteries
1. Remove the battery cover on
the back of the Remote.
2. Insert one 9-Volt battery (not included)
into battery compartment,
following indicated polarity.
3. Replace the Remote battery cover.
4. Turn the tabs out and remove the
battery compartment from the bottom
of the Stunt Car. See Figure A.
5. Insert four “AA” batteries (not included)
into the battery compartment,
following the indicated polarity.
CAUTION! Replace all batteries at
one time. Also, all batteries must be
of the same type and charge level.
Figure A
Battery
Compartment
Tab
Car
Switch
6. Slide the battery compartment
back into the Stunt Car.
7. Turn the tabs inward to lock the
battery compartment into place.
Operation
CAUTION! Keep all spectators a safe
distance away while during use.
Note: Take time to get familiar with the
controls of the Stunt Car in a location
that will be relatively safe for use.
Note: Read through this section
completely and get familiar with the
controls BEFORE using Stunt Car.
1. Extend the Antenna on the Remote.
Figure B
Throttle
(GO/BACK) Steering
Remote
Switch
2. Turn Remote Switch on. The LED on
Remote will light. See Figure B, above.
3. Turn Car Switch on. See Figure A,
previous page. The LED lights
in the wheels will activate.
4. Place Stunt Car on floor
with wheels down.
5. To move Stunt Car forward, push
Throttle up. To move Stunt Car
backward, push Throttle down.
To increase speed, push Throttle farther.
8. Use the Steering control to
steer the Stunt Car.
9. To stop the Stunt Car,
release the Throttle.
10. If the Stunt Car rolls onto its
back, the small trick wheels will
allow it to continue moving.
11. After use, turn Car Switch off, then turn
Remote Switch off, and retract antenna.

3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • [phone]
Maintenance
1. Keep the Stunt Car clean and dry.
2. Store the Stunt Car inside
the original foam packing out
of the reach of children.
3. Properly recycle all used batteries.
Record Serial Number Here:
Note: If product has no serial number,
record month and year of purchase instead.
Note: Replacement parts are not available.
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality
and durability standards, and warrants to the original purchaser that this product is free from
defects in materials and workmanship for the period of 90 days from the date of purchase.
This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence
or accidents, repairs or alterations outside our facilities, criminal activity, improper installation,
normal wear and tear, or to lack of maintenance. We shall in no event be liable for death,
injuries to persons or property, or for incidental, contingent, special or consequential damages
arising from the use of our product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation of exclusion may not apply to you.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation
charges prepaid. Proof of purchase date and an explanation of the complaint must accompany
the merchandise. If our inspection verifies the defect, we will either repair or replace
the product at our election or we may elect to refund the purchase price if we cannot readily
and quickly provide you with a replacement. We will return repaired products at our expense,
but if we determine there is no defect, or that the defect resulted from causes not within
the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.