Harman Kardon AVR 430 Manual

The Device Priority mode allows you to select the length
of time that the remote continues to issue codes for a
device other than the AVR or DPR once you use the
remote to control a source or other product. The default
operation for the remote is to have all buttons on the
remote return to their AVR/DPR functions 5 seconds
after the last button press. However, you may program
the AVR/DPR remote to remain active as the source
device remote for 12 seconds, or to keep the source
device’s codes active until another Input Selector is
pressed. If you wish to keep the default setting of a
5-second return, no changes are needed.
To change the device priority timing, follow
these steps:
1. Press and hold the Program Button for about 3
seconds while the message shown in Figure 1
appears in the remote’s LCD Information Display.
Release the button when the red light under the
Set Button appears.
Figure 1
2. The remote’s MAIN MENU message (Fig. 2)
will appear in the LCD display and the Set Button
will remain illuminated in red. Press the
⁄
/
¤
Navigation Buttons until DEVICE PRIOR-
ITY appears in the bottom line of the LCD screen,
as shown in Figure 3, and press the Set Button.
Figure 2
Figure 3
3. When the DEVICE PRIORITY message
appears in the remote’s LCD display (Figure 4),
press the
⁄
/
¤
Navigation Buttons to select the
option that best suits your needs.
Figure 4
• When NORMAL appears on the bottom line of
the LCD, the remote will revert to AVR/DPR control
5 seconds after the last button press, when you
are controlling a source device.
• When EXTENDED appears on the bottom
line of the LCD, the remote will revert to AVR/DPR
control 12 seconds after the last button press, when
you are controlling a source device.
• When LAST USED appears on the bottom
line of the LCD, once you press one of the Input
Selectors, the remote will continue to operate using
the codes for the selected source device, until another
device is selected. If you choose this option, please
remember that you will have to press the AVR
Selector in order to use the remote to operate the
AVR/DPR for functions such as surround mode selec-
tion, but the Volume and Mute controls will continue to
remain active in their AVR/DPR modes at all times.
4. Press the Set Button one more time. The LCD
display will show the word SAVING on the top line
for about 2 seconds and then flash SAVED four
times on the bottom line to indicate that the setting
has been accepted by the remote’s memory.
DEVICE PRIORITY
NORMAL
MAIN MENU
DEVICE PRIORITY
MAIN MENU
PROGRAM DEVICE
HOLD PROG BUTTON
FOR 3 SECONDS
DEVICE PRIORITY TIMING
(FOR AVR 7300, AVR 630, AVR 430, DPR 2005 AND DPR 1005)
© 2005 Harman International Industries, Incorporated
Harman Kardon is a registered trademark of Harman International
Industries, Incorporated.