Harman Kardon Enchant Series User manual

DEMO MODE
Description
1. Remote control function is disabled
2. Bluetooth and Wi-Fi are disabled
3. The soundbar will not enter standby mode
4. Demo mode will remain active, even after power cycle
5. The soundbar features a general version of the MultiBeam surround eect that can work for
most rooms.
6. The soundbar will features a default volume level that resets after 90 seconds of inactivity.
7. Only VOLUME UP, VOLUME DOWN, and SUBWOOFER PAIRING buttons are enabled on the
soundbar.
8. The soundbar will automatically detect ONE active demo source input: OPTICAL, AUX,
or HDMI ARC connectors. Once the soundbar has detected the demo source input, the
soundbar will remain on this input and will not change.
9. If a subwoofer is paired, a user can mute the subwoofer by pressing the VOLUME UP and
DOWN buttons at the same time.
To Enable Demo Mode
1. Remove the power cable from the soundbar.
2. Connect ONE audio source to the soundbar back-panel connectors: Optical, Aux, or HDMI
ARC.
3. Plug in the power cable while pressing and holding VOL UP & SOURCE buttons on the
soundbar top-panel.
4. The front display will display “DEMO” to indicate that the bar is in demo mode.
5. The soundbar will enter subwoofer-pairing mode. If connecting to a subwoofer, press the
PAIRING button on the subwoofer to connect
To Disable Demo Mode
Repeat the Steps to Enable Demo Mode
Demo Mode and Hotel Mode Instructions for
Harman Kardon Enchant Soundbars

HK_Enchant Soundbars _Demo Mode and Hotel Mode Instructions_V1_20180727
HOTEL MODE
Description
1. Hotel mode will remain active, even after power cycle
2. Installer can dene the default source input when the product is turned on after standby
mode. A user can change the source at any time during operation.
3. Installer can dene the maximum volume level
4. The soundbar assumes a comfortable listening level when powered on.
To Enable Hotel Mode
1. Press and hold the remote control DIM button for 3 seconds, then quickly press SKIP BACK,
then SKIP FORWARD. The Display will show“Hotel”.
2. The soundbar will enter subwoofer-pairing mode. If connecting to a subwoofer, press the
PAIRING button on the subwoofer to connect.
3. The display will show“choose default source”. Press the SOURCE button on the remote control
or top-panel, then press the POWER button to conrm.
4. The display will say“set max volume”. Press the VOLUME UP and VOLUME DOWN buttons to
set the maximum volume, then press the POWER button to conrm.
5. Front display will display“READY” to indicate that the bar is in Hotel mode.
To Disable Hotel Mode
Repeat the Steps to Enable Hotel Mode