Harman harman/kardon HK OMNI 10 User manual

Quick Start Guide
Guide de demarrage rapide
Buttons
Connections
What’s in the box
x1
x1
Bluetooth®
AUX input source
HK OMNI 10
HK OMNI 10
WPS
12
APP
harmankardon.com/HK Omni10
H/K Connect
H/K Connect
1s
Multi-room music streaming
1s
Single button Play / Stop functionality
Setup and Control your Harman Kardon wireless system with the required HK Connect app.
3s
Party Mode
AUX
HK OMNI 10
Full owners manual
Bluetooth® paring mode
Bluetooth® reconnecting
Bluetooth® connected, no streaming
Bluetooth® connected, streaming
LED Status LED Behaviors
Slash - Blue blinking
Ring - Blue blinking
Slash - Blue blinking
Ring - Off
Slash - Solid Blue
Ring - Off
Slash - Solid Blue
Ring - Solid Blue
Aux active
Inactive
LED Status LED Behaviors
Slash - Solid White
Ring - Solid Green
Slash - Solid White
Ring - Off
Network streaming
Source switching
LED Status LED Behaviors
1x
Slash - Solid White
Ring - Solid White
Ring - Multicolor blinking
Party Mode
LED Status LED Behaviors
3s Ring - Multicolor blinking
Out of the box (Restore Factory Setting)
LED Status LED Behaviors
Slash - White blinking
Ring - Off
Mute
LED Status LED Behaviors
FPO

FCC Information and Copyright
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment .This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.