Harman JBL JS-120 User manual

Features
• Designed for the L100 Classic
• Also supports the original L100, L100A, L100 Century,
4312E, 4312SE, 4312G and 4319
• 4 rubber-tipped floor feet are included
• Packed and sold in pairs
• Metal construction with black finish
Specifications
Rear Height (bottom of speaker): 5.65" (143.4mm)
Rear Riser Height: 9.29" (235.9mm)
Rear Height (including riser): 9.29"
Front Height (bottom of speaker): 7.075" (179.7mm)
Tilt-back angle: 7 degrees
NOTE: Feet are adjustable in height
JS-120 Loudspeaker Stand
7°
10.082 in.
(256.1mm)
12.677 in.
(322mm)
14.252 in.
(362mm)
7.126 in.
(181mm)
7.077 in.
(179.8mm)
11.732 in.
(298mm)
3.667 in.
(93.15mm)
11.047 in.
(280.6mm)
9.287 in.
(235.9mm)

© 2018 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of HARMAN International
Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance
are subject to change without notice.
HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jblsynthesis.com
JS-120 Loudspeaker Stand
JS-120 LOUDSPEAKER STAND ASSEMBLY INSTRUCTIONS
Step 1 - Locate the parts (packed with the stand) that contains 4 pieces of rubber feet. Place the stand upside down and install the
bottom base with rubber feet as shown below. Tighten the rubber feet in clockwise direction.
Step 2 - Place your loudspeaker as shown.