
www.SafetyGrip.com | Page 3
STEP 1: Position the Bath Hand Rail
Position the Bath Hand Rail over the edge of the bath tub where you want it located.
STEP 2: Securely Tighten The Clamp
Securely tighten the clamp onto the side of the bath tub using the Hex Key. There are 3 non-slip surfaces on this
Bath Hand Rail. Make sure that all 3 are in full contact with your bath tub surfaces where you are mounting this
unit. Finally, make sure that the Bath Hand Rail does not move when you push and pull on it.
Installer Note: Keep the Hex Key because you will need it to maintain the safety of your Bath Hand rail
MAINTENANCE
• The Bath Hand Rail is installed on a smooth surface and can loosen with use. Check the installation and the
Clamping Screw weekly.
• To clean your Bath Hand Rail, simply wipe with a clean cloth and any commercially available cleaning
solution.