Hasbro Nerf N-Strike Disk Shot 56855 User manual

A. CAUTION: DO not airn at my@? or ~8.
NOTE: For indoor

rker (notincluded)
compartment mar
(I- sta
@'&a&& to cover). Famover cover.
Insert 2 r GV' 'AM" or RO3 size battertes.
Replacer cover-and tighten screw.
A CAUTION: TO AVOID BATTERY LEAKAGE
1. As with allsmall batteries, the batteriesusedwiththis toy should be kept away
from small childrenwho stillputthings Intheir mouths. Ifthey are swallowed,
promptly sea a doctor and have the, doctor phone [phone]collect. Inother
countries, have the doctor call your local poison control center.
2. MaRe sure the batteries are inserted correctlyand always follow tha toy and battery
manufacturers' instructions.
3. Do not mix old batteries and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
4. Always removeweak or dead batteriesfrom the product.
IMPORTAN1 BATTERY INFORMATION
Please retainthis information for future reference.
Batteriesshould be replacedby an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to Insert item
correctly by matchingthe + and - polarity markings.
2. Do notmixold batteriesand new batteries or standard (carbon-zinc) with alkaline batterles.
3. Removeexhausted ar $@adbatteries from the product.
4. RemoveBatteries if product isnotto be playedwithfor a longtime.
5. Do netshort-circuit the crossterminals.
6. .Shouldthls product causa, or be affected by, local electrical interference, move itaway from other
eleotried equipment. Reset(switching off and back on again or removing and re-inserting batteries)
If necessary.
7. RECHARGEABLE BATTERIES: Do not mixthese wlth any other types of battery. Always remove from
the productbefore recharging. Rechargebatteries underadult supervision. DO NOT RECHARGE
OTHER TYPES
OF BATTERIES.
8. As with allsmall items, these batterles should be kept away from children. Ifswallowed, seek
medical attention immediately.

N-S7'RIKE DISK SHOTM BLAS7ER
Launch Button
Wireless Remote
Motton Button
Pull Bad Mechanlsm
6 Mlcm Dartsm
~rlgger
SETnNG UP 7HE GAME
1. Conned the PowerAdaptor to the Disk Launcher 2. Attachthe LoadingArm to the back of the
first, then plug itintoan electric outlet. Disk Launcher, as shown.
3. Pull back the LoadingArm and insert
the Disks, with the black side of Disks
facing you. The Disk Launchercan holda
minimumof one Disk or a maximum of
12
disks. (AdditionalDisks sold separately.)
4. Placethe Disk Launcheron a levelfloor. A
Safety Switchon the bottom
of the unitwill
registerwhether or not the launcher is resting
on a levelfloor. Ifthe Disk Launcher is not
restingon a flat surface, the motor will turn
off and the Disk Launcherwill not function.
NOTE: Do not positionthe Disk Launcher so that Disksare indanger of hittingwindows, furniture,
television
or stereo equipment, fragile objects, containers of liquid, plants, people, or pets.

The Wireless Remote, which you can attachany
N-STRIKE5blasterwith a railsystem, operates
likethe remote control to your
TV: it sends out an
invisible beam, which activatesthe Disk Launcher.
You must aim the Wireless Remoteat the Disk
Launcher inorderfor itto function.
Mountthe Wireless Remoteonto the blasterrail
by slidingand locking
it into place.
GAME PLAY
Turn the Disk Launcher ON. The ON switch is
located at the bottomfront of the Disk Launcher.
You will hear
a singletone, and the lights on
the Launcherwill lightup.
When you playwith this product, it is
recommended that you stand at least 8 to 12
feet away from the Disk Launcher.
TO LOAD WE BLASER
1. Inserta dart intothe barrel of the blaster.
The Disk Launcher hastwo heightsettings,
to controlhow highit launchesthe Disks: the
low settingis up to 7 feet (2.1 meters); and
the
high setting is up to 9 feet (2.7 meters).
The default setting islow. Take note of the
ceiling height in the room you're playing in,
and setthe launch height accordingly.
To change the heightsetting,
press the Height
Adjustment buttonon the front of the Disk
Launcher. The top light indicates
the high
setting;
tha bottom light, the low setting. To return
to the defaultsetting, press the buttonagain.
2. Pull backthe cocking mechanism.
3. Pullthe trigger to fire.
4. Repeat steps I and 2 with dartsfrom the
blaster's storage compartment.

Name Disks Launched Total Hits

Name Disks Launched Total Hits

FOR ALL GAMES
1. Aim the blasterat the Disk Launcher.
2. Press theWireless Remote'sLaunchbutton. You will see three redlightsgo on, on the Disk Launcher.
3. You will hearone longtone, followed by three short tones. This isa countdownto Disk launch. The
three redlightswill go off, insequence and intime with each tone, and then a Disk will launch.
TIP: Keepyour arm straight when firing the
blaster.As the Disk flies into the air, watch
for it to reach its highest point beforefalling:
firing at the Disk at this moment increasesthe
likelihoodof hittingyour target.
If you do not play with this productfor more
than approximately three minutes, it will enter
"Sleep Mode." Once the unit enters Sleep
Mode, you will need to turn the unit off and
back on againto start playingagain.
HOW TO PLAY
as a hi. To launch another Disk, you need to aim your
and press the Wireless Remote's Launch button agam.
NOTE: If, afterplayinggames 2 and 3, you wishto play game 1, pushthe MotionButtonwhen the
ATOW isbackat the center and this will stopthe motion.

Feelfree to make upyour own games, as you play with this product!
For example,
if you are playingwith a friend, you could launchsix Disks and play "Best of Sixn:
whoever hitsthe most Diskswins.
Ifyour friend has his or her own N-STRIKEQblaster (soldseparately), one player could launch the
Diskswith a Wireless Remoteand both players couldtry to hitthem at the same time.
rips
This productisfor indoor use only. Do not take the Disk Launcher outdoorsor expose itto
naturalelements such as wind, rain, or snow. Play ina clear, open indoor area.
Do not usethe Disk Launcheror play this game with anything other than N-STRIKEQblasters.
FCC STATEMENT
I'm pressingthe Wireless
Remote buttons and nothing
is happeningwith the Disk
Launcher.
One of the Disks appears
to be stuck.
The three
(3) LED lights
on the unit are flashing.
A tone is repeatingand
will not stop.
This device complieswith part 15 of the FCC Rules. Operation issubjectto the followingtwo conditions:
(1) Thisdevice may not cause harmful interference,and (2) this device must accept any interference
received,including interferencethat may cause undesiredoperation.
Warning: Changes or modifmtions to this unit not expressly approved by the party responsible for
compliancecould void the user's authorityto operate the equipment.
This equipment has beentested and foundto comply with the limitsfor a Class
B digital device, pursuant
to part 15of the FCC Rules. These limitsare designedto providereasonable protectionagainst harmful
interferencein
a residentialinstallation.This equipment generates, uses and can radiateradiofrequency
energy, and, if not installedand used in accordance with the instructions, may cause harmful interference
to radiocommunicatbns.However, there is noguarantee that interferencewill not occur ina particular
installation. If this equipment does cause harmfulinterferenceto radioor televisionreception, which can be
determinedbyturning the equipment off and on, the user is encouragedto try to correctthe interferenceby
one or more of the following measures:
Reorientor relocatethe receivingantenna.
Increasethe separation between the equipment and the receiver.
Consultthe dealer or an experiencedradiomtechnicianfor help.
Connect the equipmentintoan outlet on a circuit differentfrom that to which the receiver is connected.
- Make sure, when you are pressingthe buttonson the Wireless Remote,
that you are aimingthe Wireless Remoteat the Disk Launcher.
- The unitmay be in Sleep Mode: turn it off and back on.
- Make sure ou havefresh batteriesinthe Wireless Remote and that the
Disk~aunderis pluggedintoa working electrical outlet.
- Unplugthe Disk Launcher and attemptto dislodge the stuck Disk.
- There are no Disks in the unit, or the LoadingArm is not attached.
- There isan error with the unit. Turn it off and unplugit. Check to make
surethere are no Disksstuck inthe unit. Turn the unit back on again.
Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.
Your Disk Shot and DC adaptor should be periodicallyexaminedfor potentialhazards. If any potential
hazards are found, please contact Hasbro Consumer affairs at 1-800-844-3733for repair or replacement.
O 2007 Hasbro. All Rights Resewed.
TM
8. @ denote U.S. Trademarks.
U.S. Pat. Nos. 5611322, 5471967 and 5529050.
56855
PIN 6679700000 Product and colon may vary.