Hasbro Nerf N-Strike LongShot CS-6 61983 User manual

EXTENSION BLASTER
2. Slide the Cocking Mechanism
backwards.
3. Pull the Trigger 1 to launch 1
STREAMLINE DART™.
CLEARING A JAM
1. Pull Bolt Mechanism back. If Bolt
Mechanism seems stuck, try pulling
the trigger first.
2. Remove the Clip before attempting to
remove the jammed dart.
1. Load dart into lower muzzle.
4. Replace Clip and slide Bolt Mechanism
forward. This should load another dart.
3. Open the Jam Clearing Door and
remove the jammed dart. Close door.
™
Questions? Call: 1-800-327-8264
Thank you for purchasing the NERF™ N-Strike LongShot CS-6™
blaster. Be sure to read and follow all instructions carefully before
using this product.
AGES 6+
61983
N-Strike
LongShot CS-6™
™
Do not aim at eyes or face.
CAUTION:
TO AVOID INJURY:
Use only darts designed for this product.
Do not modify darts or dart blasters.
N-STRIKE LONGSHOT CS-6
™
WITH 12 STREAMLINE DARTS
™
Use both blasters separately or snap them together to create the
N-Strike LONGSHOT CS-6.
© 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S.Patent Nos. 6083127, 5529050 and Patent Pending.
61983 P/N 6594260000
Trigger 1
Cocking
MechanismTrigger 2
Bolt Mechanism
Product and colors may vary.
Clip Storage
Jam
Clearing
Door
Bipod
Ready Indicator
Sight
Clip
Clip Lock Button
Dart’s Holding Tube

N-Strike LONGSHOT CS-6
™
To Assemble:
1. Insert Bolt into mechanism as shown
and plug onto other end of bolt.
2. Stock extends.
3. Slide/snap Sight onto Blaster. Lock
into place.
4. Insert grip and slide back to snap
into place.
5. Attach extension to main unit by
sliding extension into place...
6. ...and twisting 90 degrees to lock.
7. Bipod flips down. 8. Load Clip by inserting 1
STREAMLINE DART™ at a time
and pushing down. Be sure to insert
darts in direction indicated on the
Clip. Each Clip can hold up to 6
STREAMLINE DARTS.
1. Pull Bolt Mechanism back. Ready Indicator should change
from black to red. Slide Clip into place.
2. Slide Bolt Mechanism forward. 3. Pull Trigger 2 to launch
STREAMLINE DART™.
4. Pull Bolt Mechanism all the way back,
and slide forward to load another dart.
5. To reload, pull Bolt Mechanism back and press Clip Locking
Button to remove Clip.
USING LONGSHOT CS-6
other side of blaster