Hausammann H115.0557 User manual

H115.0557 Manual for automatic
dispenser for sanitizer
Technical Specification
Product Dimension : 25 x 15 x 10cm
Battery : Alkaline AA 1.5v (4 Pcs)
Battery Life : > 20000 times / Shot, Stanby mode 2 years
Volumn / Shot : 1-2 ml / Shot
Speed / Shot : 0.6 ~ 0.8s / Shot
Sensing Distance : 1cm ~ 10cm
Manual automatic dispenser www.hausammann.com
Feature
1) Sensing: Sensor will activate only around sensing area,
one shot / sensing, maximum sense distance 10cm
2) Sensing Setting:
1) Switch upwards Figure 1, 2 shots / sensing
2) Switch downwards Figure 2, 1 shots / sensing
3) Low Battery Indicators: Low battery indicator see
Figure 1 Flashes red rapidly when batteries should
be changed ) See Figure 3.
4) 4)Low Liquid Indicators: Low liquid indicator see
Figure 2 Flashes green rapidly level is low and
need change the bottle with full liquid. See Figure
3.
5) Product Mal function: Flashes red and green
rapidly See Figure 1 and Figure 2
Operation
Place hand at the bottom center of product, about 1 cm ~
10cm distance, Wait around 1 second for soap to dispense. If
need more soap, just move hand away from sensing area,
then move hand back to sensing area. Repeat if necessary
Precaution
1. Product install at indoor with proper ventilation.Avoid direct sun light and rain.
2. During transportation, container with liquid should be remove from the product to avoid liquid
leaking to the product controller and circuitry
3. When indicator low battery flashes, batteries need to be replaced as soon as possible.
4. Product can be cleaned with damp cloth and wipe with dry cloth later. Do not splash with
water.

H115.0557 Manual for automatic
dispenser for sanitizer
Opening Dispenser
Dispenser cover may be opened by inserting key in slots
on top of cover and depressing latch (Figure 1) or using
optional push button (Figure 2)
Manual automatic dispenser www.hausammann.com
Mounting Dispenser
For porous, textured, or wallpapered surface, screw
mounting is recommended. Ensure that mounting
hardware is appropriate for your wall surface.
The dispenser may be mounted using a minimum of two
(or four) self-tapping screws and wall anchors. Ensure that
proper mounting hardware is used for your wall
composition.
Changing Batteries
Batteries are located inside of protective foam insert.
1. Open dispenser cover
2. Install 4 "AA" size Alkaline batteries according to
proper polarity. See figure 1. Use only new 4 "AA"
Alkaline batteries.
3. Reinstall battery cover ensuring to is securely
tightened
Installing Refill cartridge or prefilled
one way cartridge in dispenser
Batteries are located inside of protective foam
insert.
1. Open dispenser cover
2. Remove cap from refill. See Figure 1.
3. Insert refill into dispenser with pump facing
down. Fig. 2
4. Lock the refill in place by sliding pump fully
into curved recess. See Figure 3.