Hay FIFTY-FIFTY COLLECTION User manual

– INSTRUCTION MANUAL –
DESIGN BY SAM WELLER
FIFTY-FIFTY
COLLECTION

 GENERAL INFORMATION 
TECHNICAL DATA
This product is supplied with an integrated LED
light source. The expected lifespan of the LED
light source is 25,000 hours, which equates to
810 years of general use. When the light source
reaches its end of life, the whole luminaire should
be replaced.
FITTING TYPE | Integrated LED
POWER W | 4W
COLOUR TEMPERATURE | 3000K warm white.
ATTENTION
Ensure that the power supply to the circuit has
clearly been turned OFF before installing the
product. In some countries, electrical installation
must be carried out by authorised electricians/
contractors; please check with your local
authority for guidance.
The product must not be modified in any way.
HAY accepts no responsibility for any products
that have been modified or tampered with. The
external flexible cable or cord of this luminaire
cannot be replaced. If the cord is damaged,
the luminaire should be replaced. This lamp is
designed for indoor use only.
CARE AND MAINTENANCE
The product can be cleaned with a soft damp
cloth and mild detergent, or a dry microfibre
cloth. Do not use alcohol or any other solvents
to clean the product and avoid using abrasive or
rough sponges. Ensure that the power supply has
been turned OFF before cleaning the product.

Lamp
 PARTS 
HandleAllen keyScrew
Adapter Power supply

The lamp can be used with several different bases and fixings.

1.
Unpack all the parts and check that you have received all the
parts listed. Unpack the lamp & base (packed separately).

2.
Carefully insert the wire retention clip into the arm lugs and ensure the wire
retention clip is secure. It may be easier to do this with the lamp lying flat.

3.
TABLE LAMP ONLY
Insert the lamp body into the base. Using the provided tool and screw, the lamp
can be fixed to the base through a hole underneath. Ensure this is not too tight
so the lamp can still rotate freely.

4.
CLAMP ONLY
Clamp the clamp base in place by adjusting the grip. Insert the lamp body
into the clamp base.

5.
TABLE INSERT ONLY
Carefully drill a 10 mm hole into a desktop where you would like the lamp to be
positioned. Insert the table insert into the hole and tighten the circular nut un-
derneath to hold firmly in place.

6.
FLOOR LAMP ONLY
Screw the upright into the floor base.

7.
FLOOR LAMP ONLY
Add the cable restraint to the upright.

8.

9.
Screw the handle into the head, ensuring it is tight before using it to adjust the
lamp’s position. The lamp can be freely moved and will hold in any position.
A touch sensitive step dimming switch is located on the backside of the lamp’s
light source.

10.
If necessary, the joints can be adjusted using the provided tool. Carefully tighten
the bolts until the lamp supports itself in any position.

11.
Plug the trailing cable into the power supply.
Attach the correct adapter for your region.
The lamp is now ready for use.

 CARE & MAINTENANCE 
Our Care & Maintenance offers guidance for optimal
maintenance of your HAY product. It includes advice
and instructions on cleaning and caring for specific
materials to prolong the life of your lighting.
Please find our Care & Maintenance
guide by scanning the QR code
You can find more relevant information on
Fifty-Fifty Collection by scanning the QR code
You can also find the same information here
hay.dk/downloads

14102021
Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
www.hay.com