Hayward AQR100 User manual

Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
www.hayward.com
AQR100
Replacement Transformer for AQR100
Installation Manual
GLXAQR100XFMR
Contents
Description............................1
Installation............................1
092739 RevA
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Description
The GLXAQR100XFMR is a replacement transformer for the AQR100 chlorine generator only.
Installation
DANGER of Death, Injury or Property Damage if procedure not followed. This component
connects to the main circuit and chlorinator cell inside of the AQR100 enclosure. Separating the
enclosure is required. Power to the AQR100 MUST be shut off before the enclosure is separated.
1. Completely remove power to the AQR100.
2. Remove the AQR100 from the mounted surface.
3 Remove the 10 stainless steel screws from the back of the AQR100.
4. As you carefully separate the enclosure, reach in and remove the ribbon cable connector.
After the cable has been disconnected, remove the front half of the enclosure and put it
aside.
Remove the 10
fasteners shown
using a #2 Phillips
head screwdriver.
Pull straight up on the
connector to remove
the ribbon cable before
fully separating the
enclosure.
1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

5. Separate the 4 conductor connector shown above. Pinch the two "wings" and pull the two
pieces apart.
6. The 2 yellow wires exiting the transformer need to be disconnected from the two rectifiers as
shown above. Pull up on the spade connectors to disconnect.
7. There are four hex head screws that fasten the transformer to the AQR100. Use a 5/16"
nut driver or proper flat head screwdriver to remove. Carefully lift the transformer out of the
AQR100.
8. To install the new transformer, reverse the previous steps.
Separate this connector by pinching
on the wings and pulling apart
Remove the four hex head screws
that fasten the transformer to the
AQR100's mounting plate.
Remove the two yellow
wires from the rectifiers
by pulling up on the spade
connectors.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2

For further information or consumer
technical support, visit our website at
www.hayward.com
Hayward is a registered trademark and AQR100 is
a trademark of Hayward Industries, Inc. © 2019 Hayward Industries, Inc.
All other trademarks not owned by Hayward are the property of their respective owners.
Hayward is not in any way affiliated with or endorsed by those third parties.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS